answersLogoWhite

0

The torque setting for the front sway bar links on a 1998 Honda Passport is typically around 37 ft-lbs (50 Nm). It's important to ensure that the nuts are tightened in a sequence that prevents binding. Always consult the vehicle's service manual for the most accurate specifications and any specific procedures related to your model.

User Avatar

AnswerBot

4d ago

What else can I help you with?

Related Questions

What is the torque setting on the front axle of a CR85 Honda?

It is 46 lbf-ft.


What is the axle nut torque on a 2000 Honda Prelude?

front- 36mm


What is the wheel bearing torque specs in ftlbs on a rear wheel bearing for a 1998 Honda Accord?

what is the torque on front wheel bearings for 1998 honda accord


Where are Honda Passport freeze plugs?

The freeze plugs on a Honda Passport are located along the front of the engine block. They allow for expansion in the event the coolant freezes to prevent cracking.


What is the torque setting for the nut that holds the front rotor on a 1999 grand am se?

Actually the nut does not hold the rotor on. Your brake caliper does that. The nut holds the front hub on. correct and the torque setting for the front hub nut is ..284 ft pounds


what is the torque setting for front axle on 05 Ford 4x2?

The setting would be around 7 route in order to have a correct setting of axle.


The front axle nut torque setting is on a 2002 Buick Rendezvous?

192 lbft


What is the Torque setting for Daewoo Matiz hub bearings?

front hub 120nm i think


What are the replacement speakers for 1999 Honda Passport?

Front 5.25 (5&1/4) Rear 4


What is the torque setting on the front hub nut on a Polaris sportsman?

The torque setting for the front hub nut on a Polaris Sportsman is typically around 30 to 40 foot-pounds, but it's important to consult the specific owner's manual for your model year to confirm the exact specification. Proper torque ensures that the hub is securely fastened, which is crucial for safe operation. Always use a torque wrench to achieve the correct setting.


Where is the power steering fluid reservoir located on a 1998 Honda Passport?

The power steering fluid reservoir on a 1998 Honda Passport is found on the driver side of the engine bay. It is located in front of the brake master cylinder reservoir.


What would cause a transmission fluid leak in a 2002 Honda passport?

AnswerIt could be your boot or seal around the transmission.My 2002 passport was leaking from the front pan, the transmission has a front and rear pan and the gasket had to be replaced.