answersLogoWhite

0

sumtimes in a moving car suddenly the car goes off.....if the car doesnt start again,...one of the reasons might b damage of rotor.. to start car again v need a rotor...

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you use rotor in a sentence?

I fixed my toilet with a rotor.


How to measure rotor thickness?

I use a micrometer the rotor should have minimum thickness stamped on the rotor is inches or millimeters


How can I use a tool to take off the rotor?

To remove the rotor, you can use a tool called a rotor puller. This tool is designed to safely and effectively detach the rotor from the vehicle's axle or hub. Simply follow the instructions provided with the rotor puller to ensure proper usage and successful removal of the rotor.


What does a helicopter use for brakes?

They use the main rotor


What is the Minimum rotor thickness for a 1997 Pontiac Bonneville?

The rotor thickness for your 1997 Pontiac Bonneville is 0.75. When the rotor falls below this thickness a certified mechanic can no longer use the rotor.


Location of cap rotor 99 intrepid?

A '99 Intrepid doesn't use a distributor, so no cap and rotor.


What is the minimum front brake rotor thickness for 1998 Chrysler sebring jxi?

The minimum front brake rotor thickness is three aids of an inch. When the rotor does not have the minimum thickness the auto mechanic replacing the brakes can not use the rotor.


What is a LP rotor?

low pressure rotor as i know in some of the thermal power plant they may use for this type of rotars


What width is to narrow for a worn brake disc?

There is a engraved number on the outer rim of the rotor. This will be where the rotor is the largest in diameter. It will be hard to read if the rotor is rusty. This number is the minimum recommended thickness. You may have to use a dial caliper to accurately measure the rotor.


How can the centerlock rotor be removed without a tool?

To remove a centerlock rotor without a tool, you can use a rubber mallet to gently tap the rotor in a counterclockwise direction until it loosens and can be removed by hand. Be careful not to damage the rotor or the hub while doing this.


Why use surge protecting resistor to generator rotor winding?

To limit the fault current used surge protective resistance in generator rotor winding to protect the rotor winding heavy damage.


How do you remove rotor that has no screw?

To remove a rotor without visible screws, first, check for retaining clips or pins that may need to be removed. If the rotor is held in place by a bolt in the center, use an appropriate socket to loosen it. If the rotor is stuck, gently tap it with a rubber mallet to dislodge it, or use a puller tool designed for rotor removal. Always consult your vehicle's service manual for specific instructions related to your model.