Variable assist Power Steering is a system that adjusts the level of steering assistance based on driving conditions and vehicle speed. At lower speeds, it provides more assistance for easier maneuverability, while at higher speeds, it reduces assistance for better road feel and control. This dynamic adjustment enhances driver comfort and handling, making steering feel more responsive and natural in various situations.
the Pump does not control this, it is internal to the steering gear system, usually a "Steering Rack" Telling if or not will be a matter of getting the Steering Rack # and checking to see if it capable of variable boost.
NV7 is with Variable Effort Steering. N40 is with Non-Variable Effort Steering. Check the "Service Parts Identification" sticker for your car. Variable Effort Steering will have an electronic control valve on one side of the power steering pump with an electrical connector. The Variable Effort Steering "EVO" valve adjust the amount of power steering assist. It is intended to make the steering stiffer at higher speeds. This helps prevent the vehicle from wandering at highway speeds.
Power assist steering and Power Steering are the same thing, just difrent names from difrent Manufacturers.
i just did a 1996 Pontiac grand am , and according to CAPS there are two separate power steering pumps for variable/non-variable steering ,so u need to verify which you have and look at the item b4 to make sure its the right one ,, why waste time ya know ---JAS
Increases assist at highway speeds to increase maneuverability
Heavy electrical load and a badly worn and or loose belt that is slipping! There is a steering position sensor at the base of the steering column that tells the variable assist power steering how fast you are turning the steering wheel. When it gets faulty, there will be lurches and surges in the steering. Easy to replace, costs about $60 from GM.
One common problem is a faulty steering position sensor. This $60 sensor, located at the base of the steering column (inside the vehicle), tells the variable assist power steering how fast you are turning the steering wheel. When faulty, it will cause lurching and surging in the steering - feels like loose parts.
The steering assist is electronic not hydraulic, therefore there is not a dipstick nor reservoir for power steering.
You have more stuff in the system than just a pump. You have a steering rack that has valves in it that could be sticking. You may have a variable assist valve if you are equipped with variable assist steering. You have lines and linkages that could a have a problem. If you installed the pump, but did not make sure the pressure valve was not in place on the high pressure line, you may have a problem there.
On a 1995 Jaguar, the variable assist valve is typically located in the power steering system. It is often found on or near the power steering rack, which is usually situated under the front of the vehicle, near the engine. To access it, you may need to lift the car and remove any covering or components obstructing the view. Always refer to the specific service manual for detailed diagrams and instructions.
You can't. The power steering is driven by the motor. If the motor stops, there is no power assist for the steering.
no because power steering is a hydrollic assist system