answersLogoWhite

0

Motorcraft BXT - 65 - 750 ( optional battery ) or Motorcraft BXT - 65 - 650

That's BCI group size 65 , 750 or 650 cold cranking amps ( CCA )

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What kind of oil do you need for a 2000 ford windstar?

According to the 2000 Ford Windstar Owner Guide ( 5W-30 )


What battery does a Ford Windstar 2000 need?

According to the 2000 Ford Windstar Owner Guide : -------------------------------------------------------------------------- If you have the 3.0 liter " Vulcan " V6 engine it either came from the factory with the Motorcraft BXT - 59 battery or the optional BXT-65-750 -------------------------------------------------------------------------- The 3.8 , V6 had either the BXT-65-650 or the optional BXT-65-750


2000 Ford Windstar Why does my back heater not blow at all?

The blower on the back heater may need to be replaced on the 2000 Ford Winstar.


Will a engine and transmission from a 2000 Ford Windstar fit in a 2001 Ford Windstar?

the transmissions are different 2000 takes ax4s 2001 take ax4n motors would fit some sensors make need to be transfered


Do you need to keep the electrical system connected when installing a new battery in a 1999 Ford Windstar?

I recently replaced the battery in our 1998 Windstar and did not keep the electrical system connected during the changeover. No issues afterwards.


Need the legend for 2000 Windstar fuse panel?

Go to Motorcraft service.com. Click on Owner Guides You can view the 2000 Ford Windstar owners manual online ( it includes the fuse diagrams )


Where is the starter on the 2000 ford Windstar?

The starter on a 2000 Ford Windstar is located on the driver's side of the engine, near the bottom of the engine block. It is positioned between the engine and the transmission, making it somewhat difficult to access. To reach it, you may need to remove some components or create space by lifting the vehicle. Always ensure the battery is disconnected before attempting any repairs.


Where is powertrain control module located on ford windstar sel 2000?

The powertrain control module (PCM) on a 2000 Ford Windstar SEL is typically located in the engine compartment, mounted on the passenger side, near the firewall. It is often positioned near the battery and may be covered by a protective cover. To access it, you might need to remove any obstructions, such as the battery or air intake components. Always refer to a service manual for exact details and safety precautions.


Transmission cooler for a 2000 ford windstar?

You can find a transmission cooler for a 2000 Ford Windstar at most auto parts stores although they generally will need to order the part and have it shipped to your local store. In general, these coolers cost around 50 to 100 dollars.


Where can I purchase right side mirror for a ford windstar 2000?

EBAY IS THE BEST PLACE TO BUY JUST ABOUT ANYTHING YOU NEED


What octane fuel do you need to run in a 2000 ford windstar?

According to the owners manual, the Windstar is happy with plain 87 octane. Anything higher is not necessary, and doesn't improve performance or mileage.


Where is the oil pressure sensor on a 2000 ford windstar?

On a 2000 Ford Windstar, the oil pressure sensor is located on the engine block, typically near the oil filter and above the oil pan. It is usually positioned toward the rear of the engine, on the driver's side. To access it, you may need to remove some components or use a wrench to reach it effectively. Be sure to disconnect the battery before attempting any repairs to avoid electrical issues.