0
What else can I help you with?
What spark plug does your 2000 mercury sable take?
Check the Vehicle Emissions Control Information ( VECI ) decal located in the front of the engine compartment ( it will show the type of spark plugs to use and the spark plug gap )
How do you take out a spark plug?
You take off the cap. Then pull out the spark plug. Put a new spark plug in. Then put the cap back on. Voila your done. Easy as pie!
What is the spark plug gap for a 1990Chevy 2500 with a 305?
Spark plug gap is where spark plug spark discharge is designed to take place. On a conventional spark plug, it is the area between the center and the ground electrode.
How do you change spark plug on craftsman snow blower?
Most snow blowers have the spark plug on top of the motor :to change a spark plug you get a spark plug wrench (take wire cap off the plug) put wrench on spark plug then turn counter clock wise to take it out. To put a new one back in reverse the proses
How do you change spark plugs in a z24 1998?
you must take the top module off the engine and then remove the rubber plugs that are on top of the spark plug, then use the spark plug sockets to get them out you must take the top module off the engine and then remove the rubber plugs that are on top of the spark plug, then use the spark plug sockets to get them out you must take the top module off the engine and then remove the rubber plugs that are on top of the spark plug, then use the spark plug sockets to get them out
What year did a spacecraft take a picture of Mercury?
Mariner 10, in 1974-1975 and Messenger from 2008 until it was crashed into Mercury in 2015.
What size spark plug socket do you need to take off plug on Honda 400EX?
You need an 18 mm spark plug socket.
How many quarts of oil does a 2010 4 cylinder mercury mariner take?
5 quarts.
How do i take off the spark plug for 660 raptor?
The best way is to use the spark plug socket out of the factory tool kit. If you do not have that use a normal 5/8" socket to loosen the spark plug. Use the spark plug wire to snap back on after the plug is loose and pull it out. The spark plug is at the very top of the engine, the spark plug wire is a real good indicator of its location.
How long did the mariner 10 take to go to mercury?
Type "Mariner 10" in your search box, hit Enter....and you'll find out more than you probably ever wanted to know about Mariner 10.
How do you know if spark plugs and wires are bad?
Take the spark plug out, push back into it's pocket, set the spark plug on a grounded piece of metal, have someone crank the engine while the spark plug is grounded (but don't hold onto the spark plug, common sense right?) if a spark appears between the little arm the spark plug works, if it doesn't spark, replace with a new plug, and if the new plug doesn't start you have a faulty wire.
How do you change spark plug on snapper sx5200 snapper snow blower?
Take off the gas cap. Take off the big plastic cover with a socket and wrench.Then put the gas cap back on. Then pull of the spark plug boot. Then take off the spark plug with a spark plug socket and wrench. It should be 13/16" socket with 3/8" drive wrench. I Think the spark plug gap is 0.025 but you would have to look at a manual.
