If the fluid level had gotten so low that you got air in the lines, you will need to bleed the brake lines. It involves opening a small valve at each caliper and/or drum and pumping the brake pedal until you push out any air and you have nothing but brake fluid left in the lines.
shut off you e-break or add break fluid it will shut off i prommis shut off you e-break or add break fluid it will shut off i prommis
In the break reservoir i believe
clutch master cylinder right next to brake fluid, the smaller one
When your master cylinder is low you either have a leak or your brake pads are worn. Inspect the system for a leak and inspect your pads before adding fluid. If all is well add fluid when it is at the add mark on the master cylinder. Use only the approved fluid listed on the master cylinder. Normally DOT3.
mine came on when I needed to add break fluid. Hope this helps
Add fluid the same place you check it. Caution: Do not overfill!Add fluid the same place you check it. Caution: Do not overfill!
Locate the Break fuid reservoir remove the lid Fill with the fluid type identified in you manual to the line on the side - Do not go over the line. replace the lid
stopping fluid
The testes and the prostate add fluid to semen
You add it through the tranny dipstick hole, pull the dipstick out and add the fluid.
You add fluid at the same place you check it.
where do you add the transmission fluid in a 1996 Honda accord 4 cylinderAnswerwhere do you add the transmission fluid in a 1996 Honda accord 4 cylinder