answersLogoWhite

0

A parts store may be able to provide these. Typically they are unique to your car and will be listed as such. In some cases, a dealer is the best solution.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

What tools are needed to replace 1995 riviera supercharged battery?

The supercharger has no battery.


What do you use to splice two battery cables together ON A 99 WINDSTAR?

"U" type cable clamps I recently needed to replace a battery cable and found them to be relatively inexpensive. Especially when I considered the labor I was going to put into making the "splice" and then weather-proofing the connection. FYI - Less than $10 for cables over 40" long.


Using A Battery Booster For Emergencies?

A battery booster is an emergency device for automobiles that can be used to jump start a car when the battery has died or has insufficient power to start the engine. A battery booster hooks into a car engine with cables that are similar to standard jumper cables. The unit contains its own battery that provides a charge when needed. In most instances, the batter booster is rechargeable so it can be used over and over again as needed.


What happens if you don't change your battery cables?

First of all battery cables don't have a replacement interval per se. The defects that usually precipitate the replacement of a cable are failure of the insulation on the cable or corrosion and wear of the end the fits to the battery post. If you don't replace the cable when needed the most common affect will be the starter motor will receive to little electrical current to start the car, the charging system will be unable to sufficiently charge the battery, or the head lights will be dim


What battery is needed to replace the one in my Palm Treo?

You need the Dantona 3.7V1400mAh Li-ion Battery for Palm Treo.


You replaced the battery in your 1989 Volvo 760 Turbo and now it cranks but no start It ran fine before disconnecting the old battery any advice?

have the cables been checked. same happened to my 87 same problem found it was the orgnial cables needed to be replaced.


How do I change the battery for a Husky rechargeable lantern?

To change the battery for a Husky rechargeable lantern, first, ensure the lantern is unplugged and turned off. Locate the battery compartment, usually found at the base or rear of the lantern, and remove the cover by unscrewing or sliding it open. Replace the old battery with a new one, ensuring proper alignment with the positive and negative terminals. Finally, secure the compartment cover back in place and charge the lantern as needed.


How can I replace bike cables efficiently and effectively?

To replace bike cables efficiently and effectively, follow these steps: Gather necessary tools such as cable cutters, new cables, and housing. Remove old cables by loosening the cable anchor bolts and pulling them out. Cut new cables to the appropriate length and thread them through the housing. Secure the cables by tightening the anchor bolts and adjusting tension as needed. Test the brakes or gears to ensure proper functionality.


What are the best maintenance tips for bike shifter cables to ensure smooth gear shifting performance?

To maintain bike shifter cables for smooth gear shifting performance, regularly clean and lubricate the cables, inspect for wear and tear, adjust tension as needed, and replace cables when necessary.


My 1993 Toyota MR2 NA is stuck in first gear Any ideas?

i just had that same problem and all i needed to do was replace one of the shifter cables. $50 used and 20 min to install i just had that same problem and all i needed to do was replace one of the shifter cables. $50 used and 20 min to install


What tools are needed to change the battery in a 1999 Chrysler cirrus?

you have to remove the drivers side tire, remove several screws that hold the plastic cover in place, behind the cover is the battery. It is held in place with a battery strap, use a 5/16 wrench to undo the battery terminals. wiggle the battery out the hole.


1993 Jeep Wrangler electrically dead with new battery No dash lights etc Cables good Sometimes the dash lights are on when you turn the key but when you try to start everything goes dead again?

Make sure the connections on the battery are good and tight, make sure there's no corosion on the battery terminals either. alternator could be discharging the batttery, check it out Answer Had same problem with a 1995. changed alternator. worked for about 2 days. Then same problem. Took it in, found it was a bad negative battery cable. Looked fine but needed to be replaced. Had the exact same problem with my 98' TJ, it is internal corrosion on the smaller of the two red wires comming off the battery and going to the PDC. Replace the Battery cable!!! Fixed the problem on my Jeep.