0
On a 2000 Acura Integra, the reset switch is located beneath the dashboard on the driver's side, near the fuse box. The select switch can typically be found in the same area, often near the odometer or instrument cluster. You may need to remove some panels to access them easily. Always refer to the vehicle's owner manual for precise locations and instructions.
What else can I help you with?
Code for 1995 Acura Legend radio code for 1995 Acura Legend radio?
I have a Acura Integra LS 1995 with an Acura Stereo, I have the Code but I can Not reset it , what are the steps to reset it? please help me ...
How do you reset the check engine light on a 1995 acura integra?
The easiest way to reset the check engine light on a 1995 Acura Integra is to unhook the battery for a few minutes. If the light is still on after hooking it up again, there is probably still a problem that needs to be fixed with the engine.
How do you reset maintain require light on 1999 acura integra?
To reset the maintenance required light on a 1999 Acura Integra, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. The maintenance light should turn off, indicating that the reset was successful. If it doesn't reset, repeat the process to ensure it's done correctly.
How can you tell if the timing is bad on a 1990 Acura Integra and how to reset it?
If timing is bad on a 1990 Acura Integra they car will either run incredibly rough out not at all. To fix the timing be sure to correctly align the distributor to the right factory specified degree.
What do you need to supercharge my 1998 Acura Integra?
A supercharger, advance the ignition timing, reset the ECU, use high octane gas.
Where is the fuel pump reset switch located on a Acura Integra?
On an Acura Integra, the fuel pump reset switch, also known as the fuel cut-off switch, is typically located in the driver's side footwell. It can often be found near the kick panel or under the dash. To reset it, you may need to press a button on the switch after it has been triggered. Always refer to the owner's manual for specific guidance related to your model year.
How do you reset the maintenance light on a 2001 acura TL 3.2L?
Turn key to position 2 and hold select and reset together for 10 secounds
How do you reset all sensors on 2001 Acura CL?
HOLD down both the SELECT and RESET buttons on the right of instrument panels. Turn on the ignition and then after 10 seconds, release both SELECT and RESET buttons. It will turn the maintenance light off.
How do you reset the maintenance required light in a 2000 Acura RL?
press the reset and select switch at same, turn ign. key to II (On) and wait 10 seconds
How do you reset oil change light on acura 2001 cl?
you turn the key to on position hold the select and reset buttons for 10 seconds and it should go off
Were is the fuel pump reset on a 2002 jeep wrangler?
Jeep does not have reset switches.Jeep does not have reset switches.
How do you reset the alarm on a 1998 Acura Integra?
The OEM factory alarm systems have a procedure that is used to reset the alarm. To do so, turn the key to on position and press the lock/unlock button. Do this three times in five seconds and the alarm with be in program mode. Here the alarm can be reset.
