Mostly you find brake lights sold in stores like Pep Boys, Ace Hardware, Auto Zone, and your local mechanic will also help you find a good brake light and be able to install it for you. But installing it yourself is not hard and you can usually find help from an associate that works at Auto Zone or Pep Boys.
First you buy a good-quality 3rd brake light kit appropriate for the mounting angle on your particular car -- see the links below for examples. If your car's left and right brake lights are separate from the left and right rear turn signals (different bulbs for the brake lights and turn signals), then you just follow the instructions with the kit. If your car has combination brake/turn lights (the same red light burns steadily for brake light or flashes for turn signal) then you must run a new wire from the brake light switch to the rear of the car to feed the new 3rd brake light -- cars with combination brake/turn lights route power from the brake light switch through the turn signal switch and then from there to the back of the car; if you try to get away without running the new wire, the 3rd brake light won't work properly and you'll backfeed other lighting circuits with random results.
The brake light is telling you there is a problem with the brakes. There could be several reasons. Have a qualified mechanic check the vehicle's brake system soon!
its a rear bulb failure indicator if it comes on when brake is first depressed it is a brake light bulb if it is on when you start the car it is a ride light or park light
The brake light bald can be accessed through the trunk of the car. Remove the rear tail light cover to access the brake light bulb.
Yes, you can buy brake pedals, but you have to make sure that they are the right ones for your car, and will works for your car. And always buy them from a trusted seller.
The light on the dash that says the emergency brake light is on could have burned out if it does not light up when the emergency brake is actually on. In some vehicles, this light will not light up until the car is put into gear to warn the driver that the emergency brake is still on.
all brake light switches are connected to the brake pedal --- any car or truck or van
If the red " BRAKE " light in your dash is coming on , then either the brake fluid level in the brake master cylinder in your engine compartment is LOW or the parking brake is on
yes
no the bar light on your instrument panel that is located on the trunk of the car diagram would light.
The brake light switch is broken or out of adjustment.
It means that there is a problem with the braking system. Have the car looked at by a repairman.Among the problems that could cause the brake light to display are:Insufficient brake fluidContaminants in the brake fluidFaulty brake cylindersWorn brake padsRuptured brake lines