0
On a 1975 Jeep CJ-5 with a 304 V8, the alternator brackets typically attach to the engine's front passenger side. The upper bracket connects to the intake manifold or cylinder head, while the lower bracket usually mounts to the engine block. Ensure that the alternator is positioned correctly to allow for proper belt alignment and tension. Always refer to a service manual for specific part numbers and installation details.
What else can I help you with?
What is the firing order for a 1975 jeep cJ5 with a 304 and where do you start on the distributor and is the IH 304 the same engine?
Try Auto Zone.com I have overstayed my welcome there.
Will a 304 engine fit in a 1998 TJ Jeep Wrangler?
Will a 304 engine fit in a 1998 TJ jeep wrangler?
Where is the voltage regulator on a cj7 1980 304 v8?
if it has a delco alternator it is inside the alternator
Will a 304 from a 1975 cj5 bolt into a 1984 cj7?
yes. jeep stanardized bell housing bolt pattern in 71 i believe. just motor mounts and exhaust and radiator to worry about.
Where to buy carb for 1972 jeep 304?
Click the links.
What are the release dates for Ryan's Hope - 1975 1-304?
Ryan's Hope - 1975 1-304 was released on: USA: 6 September 1976
Did jeep put a 360 motor in a 1984 cj7?
Not from the AMC factory... the stock Jeep V8 option was the 304.
Will a AMC 304 V8 fit in a 1982 jeep Cj7?
Yes
Can you put ac in a 76 cj7 304 anto?
yes. check out jeep air
What is the timing set for a 1975 Jeep CJ5 304 Engine?
The timing set for a 1975 Jeep CJ5 with a 304 engine typically calls for an initial ignition timing of around 5 to 10 degrees before top dead center (BTDC) at idle. It's important to check the service manual for specific requirements, as factors like altitude and modifications can affect timing. Additionally, the timing should be adjusted while the engine is warmed up for the most accurate setting. Always ensure to use a timing light for precise adjustments.
What motor is in a 1974 Jeep CJ5?
Could have a 258 cid I6 or a 304 cid V8
Jeep 304 fuel pressure?
With mechanical, cam driven fuel pump, about 3-5 psi.
