To fill a Muncie 4-speed transmission with fluid, locate the fill plug on the side of the transmission case, typically near the top. Remove the fill plug using a socket or wrench, and use a funnel or a hand pump to add the appropriate Transmission Fluid until it reaches the bottom of the fill hole. Once filled, replace the fill plug securely to prevent any leaks. Always refer to your specific vehicle’s manual for the correct fluid type and capacity.
To check the fluid level in a Muncie 4-speed transmission, start by locating the fill plug on the side of the transmission case. Remove the fill plug using a wrench; the fluid level should be just below the fill hole. If fluid drips out when the plug is removed, the level is adequate. If not, add the appropriate type of transmission fluid until it reaches the desired level.
in the trans Fill/Level check tube in an automatic. in a 5 speed there is probably a port to fill into the actual trans case
There is a fill plug on the right side. Fill to the bottom of the hole
There will be a fill plug on the side of the trans, fill it until fluid comes out of the hole and seal it back up.
Fill it at the same place you check the fluid level.
Fill it up until it is just below level with the fill plug. Running the car with low fluid could cause the tranny to seize.
don't know exactly but just keep filling until it starts to run out the fill hole.
There is no dipstick on a manual trans. there should be a drain plug and a fill plug on the side of the trans. To check the level you take out the fill plug and the fluid should come to the bottom of the hole.
You fill the trans fluid thru the dipstick you check the level at.
You squirt it into the fill hole on the pass side of the trans case after removing the fill plug.
you use the trans dipstic tube to add or fill with fluid.
You have to fill the trans fluid through the dipstick tube.