To replace the positive battery cable on a 1996 Ford Aspire, first disconnect the negative battery terminal to ensure safety. Then, remove the bolt securing the positive cable to the battery terminal and detach the cable. Install the new positive cable by connecting it to the battery terminal and tightening the bolt securely. Finally, reconnect the negative terminal to complete the process.
Remove - battery cable Remove + battery cable from battery and starter solenoid Route new cable following original routing Connect to starter solenoid Connect to + battery terminal Connect - battery cable
The one hooked to the negative battery post. The positive post is slightly larger.
Answer Red cable (+) goes to starter solenoid and Positive side of battery Black (-) cable goes to engine ground. When disconnecting a battery always disconnect the ground cable from the battery first. When connecting a battery always connect the ground cable to the battery last.
Follow your red or positive cable from the battery down. It is connected to the starter.
It should be attached to the short positive battery cable.
Follow the positive cable from the battery, it will lead right to the starter.
On the bellhousing next to the engine. Follow the big positive battery cable.
Did you figure it out? Because I'm trying to figure it out myself.
The starter solenoid should be located on the inside fender close to the battery. It will have the positive battery cable connected to it.
it is located on the side of the passenger side front fender. usually by the battery. if its not then just follow your positive battery cable.
its mounted on the fender well under the hood on the same side as the battery, the positive battery cable will be connected to it