answersLogoWhite

0


Best Answer

Answer Red cable (+) goes to starter solenoid and Positive side of battery Black (-) cable goes to engine ground.

When disconnecting a battery always disconnect the ground cable from the battery first. When connecting a battery always connect the ground cable to the battery last.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you hook up a 1990 ford f150 battery?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where do you hook the code reader on a 92 ford f150?

Somewhere in the engine compartment ( battery side ) you will find an EEC TEST connection for your OBD I / EEC - IV system


What would cause a engine to turn but not start after changing the battery 1986 ford f150 302?

do u have spark and fuel???? do u hook up the jump per cables back words ??????


Where can I find a key code for a 1998 ford F150 truck?

take the truck to your local ford dealer. they can hook up their scan tool and read the code.


How do you reset the fuel pump on a 1998 ford explorer?

un hook the battery then rehook battery should reset if not then bad sensor some where


What kind of damage would be done to a 97 ford F150 if tow truck hooks cables wrong what could?

were did the tow truck hook the cables at ????????


How do you hook up battery cables on 1990 Nissan 240sx?

like anything else, black is neg red is pos


What fuse runs the Tail lights on a trailer hook up ford f150 Triton?

The bulbs on trailer look good.Lights on truck work.Might be ground not sure.Looks ok.


How do you change the battery in a 1997 Ford Thunderbird?

disconnect the 97 Thunderbirds battery cables. Find the battery hold down and remove it. Lift the battery out, then lower the new one in. Install the clamp and hook up the cables.


If a 1989 Ford Mustang 2.3 air cooling fan does not work where is the relay for it or can you just bypass it and hook it up to the battery?

Yeah, you can hook it to the battery. If you do that be sure to hook it to a switch with a nice bright LED or a line that is only active when the key is turned. I made the mistake of not doing that a few years ago and the fan ran until my battery went dry.


1993 ford tempo changed the solenoid it started now it does nothing replaced the battery but it acts as tho there is no battery in it any suggestions?

make sure the small wire is hook to the post


How do you make a battery run windmill?

hook a battery to it


How do you reset the check engine lite on a ford focus?

Try dissconnecting your neg. battery terminal and waiting a couple of minutes. Then hook it back up and see what happens. Try dissconnecting your neg. battery terminal and waiting a couple of minutes. Then hook it back up and see what happens. Try dissconnecting your neg. battery terminal and waiting a couple of minutes. Then hook it back up and see what happens.