answersLogoWhite

0

Dodge does not use inertia/reset switches.

Dodge does not use inertia/reset switches.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is fuelpump wiring disconnect located?

What vehicle?


Where is the crankshaft sensor located on a dodge stratus 2006?

The crankshaft sensor on a 2006 Dodge Stratus is located on the bottom of the engine near the oil filter. It tells the vehicle's computer where the crankshaft is located at any given moment. On the v6 it is on the top of the bell housing.


How do you reset the cut off switch and where is it located on a 1996 Chevy tahoe?

There is no inertia switch on any GM vehicle.


Where is emergency fuel shutoff switch on a 93 Pontiac transport?

Gm vehicle do not have inertia/reset switches.Gm vehicle do not have inertia/reset switches.


Where is located fuelpump shutoff switch?

I am no expert but I believe on some vehicles, it is located in the trunk area of the vehicle. Pull the carpet covering in the trunk area away from either the passenger side or driver's side and see if there is a cutoff button


Can you bypass inertia switch in a 97 S10 4x4?

There is no inertia switch on this vehicle.


Where is the inertia switch on 2004 Ford Freestar Van?

On a 2004 Ford Freestar : The fuel pump inertia switch is located in the cargo area behind the service panel cover on the passenger side of the vehicle


Where is the crankshaft position sensor located at on a 2005 dodge stratus 2.4 liter?

The crankshaft sensor on a 2005 Dodge Stratus 2. 4 Liter is located on the bottom of the engine, near the oil filter. It constantly monitors the rotation of the crankshaft and updates the vehicle's computer on its current state.


Where is the starter located on a 1998 dodge stratus?

On a 1998 Dodge Stratus, the starter is located on the lower side of the engine, near the transmission. Specifically, it is positioned on the driver's side of the vehicle, mounted to the engine block. Accessing the starter may require removing the battery and some components in the vicinity for better clearance.


Where is inertia switch on Cadillac?

Ford vehicles have this switch, no GM vehicle use an inertia switch.


Where is the Jack placement for a dodge stratus 1998?

For a 1998 Dodge Stratus, the jack placement is typically located under the rear of the vehicle, near the rear axle. There are designated jack points on the vehicle's frame, often marked by notches or symbols that indicate where to place the jack. It's important to consult the owner's manual for specific instructions and safety precautions before lifting the vehicle.


Is a dodge stratus a positive grounded vehicle?

No, it is negative ground.