That would depend on which engine you have .
On my 1995 Ford Explorer , with the 4.0 L - OHV - V6 engine , it's on the drivers side
of the engine below the Power Steering pump
why does the transmission slip or shift hard on a gs Lexus 300 2001
The ambient temperature sensor in my 94 GS300 is located between the back side of the bumper and the condenser unit/radiator. It's about the size of a AA battery. That may be the best place to look.
5W-30 Synthetic Oil.
To remove the radio check this link out. It gives instructions. www.installer.com/pdf/95-8152.pdf
SPARK PLUG GAP2001 Lexus GS300 3.0L SFI DOHC 6cylThe Spark Plug Gap.044 (In thousandths of an inch)
For a 2001 Lexus GS300, the recommended transmission fluid is Toyota Type T-IV (also known as Toyota WS). It's crucial to use the specified fluid to ensure optimal performance and longevity of the transmission. Always check the owner's manual for any updates or specific recommendations. If in doubt, it's best to consult with a professional mechanic.
Wher are the oxygen sensors located on a 2001 rx300 Lexus SUV
Where is the oil sending unit located on the 2001 Chevy 43. vortec engine?
To enable the audible beep and flashing lights when locking the doors on a 2001 Lexus GS300, you typically need to access the vehicle's settings through the key fob. Press the "lock" button on the key fob multiple times, or refer to the owner's manual for specific instructions, as the procedure may vary slightly. Additionally, you can check if the feature is activated via the vehicle's onboard settings or by consulting a Lexus dealer for assistance.
The oil filter on the 2001 Lexus 300gs is on the side of the engine closest to the radiator. It is inside of a canister.
5.7 qts with filter, look in your manual. I was shocked to find this out and made sure the mechanic I use was aware, he went to LEXUS web site and found same answer.
To change the spark plugs on a 2001 Lexus GS300, first ensure the engine is cool and disconnect the negative battery terminal. Remove the engine cover and spark plug wire harness to access the spark plugs. Use a socket wrench to carefully unscrew and remove the old spark plugs, then install the new ones, ensuring they are properly gapped. Finally, reconnect the spark plug wires and battery terminal, and replace the engine cover.