answersLogoWhite

0

On a 1986 Chevrolet 350 engine, the crankshaft position sensor is typically located near the bottom of the engine, often mounted on the timing cover or near the crankshaft. For some models, it may be positioned near the flywheel or harmonic balancer. Always refer to a specific service manual for detailed diagrams and exact locations, as placements can vary slightly based on the vehicle's configuration.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

Where is the crank position sensor located on a ford 350 xl 5.8 liter?

The crank position sensor is located by the crank shaft on a ford 350 xl 5.8 liter.


Where is the crank case vent on an 86 Chevy 350?

Usually it vents from the valve cover.


Where is the crank shaft sensor located on a 1995 Pontiac trans am 350 motor?

Does your vehicle have the LT1? if so there is no crank sensor.. there is an optic sensor in the distributor that controls all..


What will cause a 1990 350 not to crank when it is getting fuel and fire and good fuses?

could be many things, probably a crank sensor


1988 Chevrolet 1500 350 cranck shaft poitioner sensor?

Gm. did not use a crank shaft sensor in 1988, It had a distributor that done everything.


Where is the Crank sensor location on a 1999 Tahoe 350?

It's on the bottom front of engine right behind the vibration dampener.


Where is the crankshaft position sensor located 1993 Chevy 350 5.7?

A 93 does not have a crank or cam sensor. Ask your question again. Tell us why you think it had a bad sensor, Tell us your symptons too.


Where is the crankcase sensor located on a 2003 pt cruiser turbo?

It does not have a crank case sensor.It does not have a crank case sensor.


Where is the crank sensor located on a 1989 caprice classic?

depending on what engine you have, 4.3 v-6 or 305 v-8 or if your lucky the 350......chevy never ran a crank sensor on an engine that old. If it wont start, check spark, if you have spark, check fuel.


Where is the crankshaft sensor located on a GM 5.7 350?

crawl under the engine, at the front where the crank pullet is you will see an elctrical connection right behond the pulley. New answer; Sorry but that is the cam sensor, The crank senor is behind the starter on the block, Depending on the year. Crank senor has never been inTHE FRONT OF THE ENGINE.


What is a crank sensor for a 1995 blazer?

A 1995 blazer does not have a crank sensor. SORRY


Where is the crank sensor located on 1989 camaro rs?

That year did not have a crank sensor.