0
It will be on the firewall side of the engine. It is near the transmission. There are two sensors mounted there......a knock sensor and the crank sensor. It's been a while and I am not sure which one is which.....but it's there. no wrong totally, its not on the transmission side it is on the belt side , in back down by the crankshaft..
What else can I help you with?
Where is the crankshaft sensor on a 97 Chevy cavalier z24?
Next to the oil filter, bolted to the block.
Is there some kind of chip that would cause my z24 to misfire I put new plugs and wires on.And I don't believe that I jummped timing.?
If its a third gen. z24 you should try to replace the coil pack housing on it. I had the same misfiring problem on my 97 z24. I replaced the plugs, plug boots, coil packs, camshaft position sensor, and crankshaft position sensor. After I replaced the coil pack housing, it stopped the misfire and made the engine run like it was supposed to.
Where is the O2 sensor located on a 1989 Chevy Cavalier Z24?
on the rear exhaust manifold hard to get to
1989 Z24 2.8 Cavalier problem car runs for 10 min then shuts off no spark. When cool will start replaced coils ignition module computer plugs and wires.?
Since you've replaced everything else associated with the ignition, try replacing the crankshaft position sensor. I'd bet that's your problem.
Is there a tach cable or electrical sensor for 1989 V6 5-speed Cavalier Z24?
its electronic cause of the distributorless ignition.
A 1989 Nissan hard-body Z24 2.4 liter engine to not rev over 3000 rpm?
maf sensor
Does crankshaft position sensor keep the fuel pump from working on a cavalier Z24?
yes If the ecm does not see rpm from senor it will not turn fuel pump on,you will only hear pump cycle during key on before crank ,but no fuel pump heard after crank tech14444
Where is the map sensor located on a 1989 Chevy cavalier z24?
the map sensor is located on the firewall to the right of the blower motor a small square box with two screws 2 minute job.
Where is the crank sensor located on the 3.1 liter Chevy cavalier z24?
On the 3.1-liter Chevy Cavalier Z24, the crankshaft position sensor is typically located near the bottom of the engine, mounted on the engine block or transmission bell housing. It's usually positioned towards the rear of the engine, close to the flywheel or flexplate. To access it, you may need to remove some components, depending on the specific setup of your vehicle. Always refer to the vehicle's service manual for precise location and removal instructions.
Where is the crank sensor located on a 1989 Z24 cavalier 5 speed?
back center of the block right above the oil pan it has 2 wires going to the one above it with one wire is the knock sensor
Would it be possible for a stuck valve on a 1989 Cavalier Z24 to cause a Misfire?
yes. a valve in the open position will prevent compression, thus no combustion.
Does the z24 cavalier have a v6?
Yes, I have a 1988 and 1989 Chevy Cavalier Z24 and they both have the 2.8L V6
