driver side on front of head, just follow the tube from the exhaust manifold on the drivers side and its there.
driver side valve cover area it is in the end of a metal tub comming up from the driver side exhause manifold.
The exhaust back pressure sensor or EBP on the 04 is located by the upper radiator hose by the block. It has a 3 pin connector and accepts a 24mm socket.
Talk2DIY Automotive - 1986 Diesel and Exhaust System was released on: USA: 16 September 2004
The oxygen sensor on a 2004 Honda Accord is found on the exhaust system. They are placed close to the catalytic converter so the sensors can properly read the exhaust flow.
No
The temperature sensor in a 2004 Duramax diesel is typically located near the thermostat housing or on the cylinder head. It helps monitor the engine's coolant temperature for proper engine operation and efficiency. You can consult the vehicle's service manual for the exact location.
The transmission sensor is inside of the transmission under the pan. The pan has to be removed to get to the sensor.
Where is the injection control pressure sensor on a 2004 ford f 350 6.0 diesel or fuel injection module?
There are two in the exhaust on the back of the engine.
There are two in the exhaust on the rear of the engine.
Bank 2 is the drivers side of the engine on your 2004 Ford F-150 Sensor 1 would be in the exhaust before the catalytic converter ( upstream ) Sensor 2 would be in the exhaust after the catalytic converter ( downstream )
In 2004, the Dodge Cummins Diesel was not equipped with an oxygen sensor. The 2007.5 and newer Cummins 6.7 liter Bluetec diesels have an O2 sensor in the downpipe. Typically, only particulate filter equipped diesels have O2 sensors.