The brake light switch is located on an aluminum air line junction block. The air line block is directly forward of the steering column on the cab side by the firewall. There is an access panel on the engine side of the firewall that gives you access for replacement.
It's by the break switch to the left of the break pedal.
There is no adjustment on 1984 thru 1989 carrera. There are 2 brake light switches which are wired in parallel and are located on the brake master cylinder.
on your brake pedal lever,its a switch,easy to remove ,just unscrew bolt and disconnect wire.
More than likely the brake light switch is defective or out of adjustment.
To change the brake light switch on a 1984 Dodge van, first disconnect the negative battery cable to ensure safety. Locate the brake light switch, which is usually mounted above the brake pedal. Remove the electrical connector and the mounting fastener to take out the old switch. Install the new switch by reversing the process, ensuring it is properly aligned and secured, then reconnect the battery and test the brake lights.
the switch is located on the cluch pedel just like a bracke switch
The fuel tank selector switch can be found on the left side of the dash of a 1984 F-150. This is immediately next to the headlight switch.
Cadillac does not use inertia switches.
The brake light may be blown (bulb) or your brake light switch might not be working.
Should be at the upper end of the brake pedal undeer the dash area
inside light on dash will not go out when the ignition switch is off
The easiest way to remove an old brake light switch(also called stop light switch) is to break it off. Simply wedge a screwdriver between the switch and the metal bracket and twist. It will pop right out. The switch has 4 ledges that lock the stop-light switch into place. It's very difficult to remove without breaking it.