Under the powersteering
The cam sensor on a 99 Buick Regal is located behind the rear cam bearing cap. It monitors the rotation of the cam and relays information to the vehicle's computer.
To change the cam sensor on a 2004 Buick Rendezvous, first disconnect the battery to ensure safety. Locate the camshaft position sensor, usually found near the engine's timing cover. Remove the sensor's electrical connector and unscrew the mounting bolt, then carefully pull out the old sensor. Replace it with the new sensor, secure it with the bolt, reconnect the electrical connector, and finally reconnect the battery.
your buick is ovisley not super charged with coil packs because its looking for a cam sensor
The 2004 Buick Regal has overhead valves (OHV).
The 2.8 engine doesn't use a cam sensor.
check your cam shaft sensor
its next to the hemi the little thing that says CAM SENSOR foo.
IS CALL CAMSHAFT SENSOR AND IS LOCATED ON THE RIGTH SIDE OF THE ENGINE , ABOVE THE CRANK PULLEY You will have a crank sensor, but it won't have a cam sensor. it dose have a cam sensor, on the timing cover left sind of water pump
Both the CAM and Crank sensor are on the front of engine. The cam semsor is to the right and held in with two smaller screws. It is actually a sealed Hall Sensor device but pretty easy to change.
It keeps the camshaft in time with the valves
Cam shaft sensor is located under the power steering pump on the block
Crank shaft sensor need replaced or cam shaft sensor