http://forums.bimmerforums.com/forum/showthread.php?t=886595
The camshaft position sensor is located beneath the wheel on a 1998 Ford Taurus 6 cylander Dohc.
I have a 1998 Metro with the 1.3l and the Camshaft Position Sensor is located on the bottom of the oil pan.
The camshaft position sensor on a 1998 Pontiac Grand Prix is located behind the rear bearing of the camshaft. It constantly monitors the rotation of the camshaft and relays this information to the computer.
in the distributor located on top rear of motor
It is located underneath the intake manifold near the rear of the engine.
I'm not sure which engine you have, but, the 2.0 has the camshaft sensor on the drivers side of the engine, right in front of the distributer
On a 1998 Chevrolet K1500 4WD with a 5.7L engine, the camshaft position sensor is located in the distributor. It is typically found at the base of the distributor, where it detects the position of the camshaft for engine timing. Accessing it may require removing the distributor cap and rotor for better visibility and reach.
The camshaft position sensor is located on the side of the engine towards the front of the car. It is toward the drivers side just below the fuel rail.
The camshaft position sensor is on the driver side end of the cylinder head.
Near bottom of trans bell housing right side
it is an part of the distributor unit. you have to change out the entire distributor.
Yes, it is inside the distributor.