It is on top drivers side just right of the exhaust manifold. It has one bolt and a cannon plug that has a clip that has to be removed before you can take it off
there is no timing belt sensor, only camshaft position sensors and crankshaft position sensor.
do you need to take off the timing belt to replace a camshaft position sensor on a 2006 kia sorento
crankshshaft and camshaft position sensors are on the right rear driver side of the engine
A camshaft position sensor detects which cylinder is firing and establishes the coil firing sequence. In a Kia Sedona, it is located at the end of the intake camshaft.
I changed only the camshaft position sensor on my 2000 Kia Sportage. So I don't think so.
To replace the camshaft position sensor on a 2008 Kia Sorento, begin by disconnecting the negative battery cable to ensure safety. Locate the sensor, which is typically found near the camshaft on the engine. Remove the electrical connector and the mounting bolt securing the sensor, then pull the old sensor out. Install the new sensor by reversing these steps, ensuring it's properly seated, and reconnect the battery.
To install a camshaft position sensor on a 2006 Kia Sorento, first, locate the sensor, which is typically situated on the rear of the engine, near the camshaft. Disconnect the negative battery terminal, then unplug the electrical connector from the old sensor. Remove the mounting bolt(s) holding the sensor in place, replace it with the new sensor, and reattach the connector and battery terminal. Finally, ensure everything is secured and check for proper operation.
TOP OF ENGINE JUST TO PASSENGER SIDE OF CENTRE. THE CAMSHAFT LOCATION SENSOR IS ALSO AT THE SAME LOCATION.
under upper timing belt cover, driver side 3.5 eng
To replace the camshaft position sensor on a 2004 Kia Optima 2.4L, first disconnect the negative battery terminal to ensure safety. Locate the camshaft position sensor, which is typically found near the cylinder head, and unplug the electrical connector. Remove the mounting bolt using a socket wrench, then pull out the old sensor. Install the new sensor by reversing the steps: insert it into place, secure it with the bolt, reconnect the electrical connector, and finally reconnect the negative battery terminal.
Cam shaft position sensor is on a rear of cylinder head -- you will see one of two cams protruding farther to the back than the other. The "blob" on its end is the cam shaft position sensor. Tightening torque for mounting bolts: 19 - 25 lb-in (1.9 - 2.6 N·m)
IAm looking for the answer for this one need help finding sesor the cam shaft sensor is on the back of the motor at the fire wall