0
If this is a 6VD1 engine, the camshaft position sensor will be located on the very back of the left bank head (on the inside, under the intake manifold). The easiest way to have it replaced or removed is to take off the intake manifold. The sensor is only secured with one 10mm bolt but it is a frustrating thing to put it back on with the intake installed, unless you have very slim hands.
What else can I help you with?
Where is a camshaft position sensor on a 2001 Isuzu rodeo?
It is located between the camshafts right behind the camshaft pulley's.
What does code PO341 mean on a Isuzu Rodeo?
PO341 Camshaft Position Sensor Circuit Range Problem
How do you repair camshaft sensor on Isuzu Rodeo?
please help
Where is a camshaft position sensor on a 2002 Isuzu rodeo 3.2L?
it does not have one, after 2000 modes the camshaft position sensor is eliminated the these vehicles use the use the VRS system to determine where the No. 1 piston is. therefore they only required a Crankshaft sensor not a Camshaft sensor.
Where is the camshaft position sensor on 1998 Isuzu rodeo?
On the drivers side head..rear of the head directly behind the intake manifold
How long does it take to replace the camshaft position sensor in a Isuzu Rodeo?
Not long at all should take no longer then 5 mins
How do you replace camshaft position sensor Isuzu Rodeo 1999?
To replace the camshaft position sensor on a 1999 Isuzu Rodeo, first disconnect the negative battery cable for safety. Locate the sensor, typically found near the camshaft on the engine, and unplug its electrical connector. Remove the mounting bolts and carefully take out the old sensor. Install the new sensor by reversing the removal steps, ensuring a secure connection and proper alignment before reconnecting the battery.
What is the tps sensor on a 95 Isuzu Rodeo?
It is a Throttle Position Sensor
How do you replace camshaft position sensor in a Isuzu Rodeo 2.2l?
To replace the camshaft position sensor in a 2.2L Isuzu Rodeo, first, disconnect the negative battery terminal to ensure safety. Locate the sensor, which is typically found near the front of the engine, and unplug the electrical connector. Remove the mounting bolts securing the sensor and carefully pull it out. Install the new sensor by reversing the removal steps, ensuring the connector is securely connected, and reconnect the battery.
Where is the camshaft position sensor on 1996 Isuzu rodeo?
On 97 & earlier it's located on the front left upper corner of the timing belt cover (3.2L). 2.2L it's on top of the front part of the cylinder head between the camshaft sprockets.
What does O2 sensor mean on Isuzu Rodeo?
oxygen sensor
How do you replace coolant temp sensor on a Isuzu Rodeo?
how do you replace coolant temp sensor on a rodeo
