Are you referring to a 200 model Metro? If so, there is no fuel filter to replace. 1998-2000 Metros have a fuel strainer in the tank. I have a 1999 Metro 3-cylinder and learned this over the summer when contacting the Chevrolet dealer. Are you referring to a 200 model Metro? If so, there is no fuel filter to replace. 1998-2000 Metros have a fuel strainer in the tank. I have a 1999 Metro 3-cylinder and learned this over the summer when contacting the Chevrolet dealer.
After resetting the fuel light on a 200 series do you have to drain the filter or do anything else?
The fuel regulator is inside the fuel filter in a lot of Saturns.
The engine of a 1996 Geo Metro weighs approximately 150 to 200 pounds, depending on the specific engine type and configuration. The Metro typically came with a 1.0L or 1.3L four-cylinder engine. This weight is relatively light compared to many other engines, reflecting the Metro's design as an economical and fuel-efficient vehicle.
the four cylinder ford contour.
The filter is on the bulk head passenger side (roughly) just underneath the windscreen
The fuel filter is located beneath the center of the car, approximately under the driver's seat. Remove the protective cover to access the filter. FYI: 2001-200 Z3 coups and roadster cars with the M54 engine are also equipped with a fuel filter that has a built-in fuel pressure regulator.
Inside the fuel tank... the tank must be dropped and the filter is part of the fuel pump assembly which includes the pump, filter and pressure regulator. Most parts stores have the whole assembly for around $200 - $250. You can do it yourself, but plan on about 3 hours for the whole job. JUST TO REPLACE A FUEL FILTER!
for the pump filter about 150 for the labor about 200-250
200 Dodge Ram pickup truck does not have a fuel filter. The only filtering device in the system is a "sock" fitted over the end of the fuel pickup tube in the gas tank.
To drain the fuel filter on a 200 Series Diesel Land Cruiser, first ensure the engine is off and cool. Locate the fuel filter, typically found near the engine bay. There may be a drain plug at the bottom of the filter; using a container, open the plug to let any water or contaminants drain out. Once drained, close the plug securely and check for leaks before starting the engine.
I believe that is ( 4.5 quarts with filter change )
Passenger side, under bash plate alongside chassis.