on the car
Because you didn't change the rest of the ignition system. Plugs, Wires, Rotor, and Cap are a must for ICM replacement.
the ignition module can be in 1 of 2 places for that year and depending on the size of motor. it will either be on the side of the distributor or on the driver side fender. if it's on the distributor, it will be gray and have a plug in it. if it's on the fender, it will be a electrical box and have 2 plugs on it.
ignition module is located under the distributor, where the spark plugs come out to go to the spark plugs, remove 6 bolts that hold the 3 capped distributor on, unplug the wires from both ends of module, 3 plugs, lift module out, nothing holds it in after distributor is removed, plug new module in, replace distributor.
Look at the Electronic Control Module. If it is the module type that looks like a dull aluminum box with 2 or 3 plugs to it, these are problematic; Replace it and keep a spare with you at all times.Look at the Electronic Control Module. If it is the module type that looks like a dull aluminum box with 2 or 3 plugs to it, these are problematic; Replace it and keep a spare with you at all times.
more apt to be the engine control module
In the front of the motor by the transmission dipstick. This is where your spark plugs from the engine go.
The ignition control module is located under the electronic ignition control module cover. On a 1997 2.4L cavalier, it will have the words 2.4L twin cam stamped on it. It is on the top of the engine and is held in place with four bolts. This cover must be removed to get to the spark plugs.
On a 2002 Ford Ranger : Check the Vehicle Emissions Control Information ( VECI ) decal in the front of your engine compartment . It will show the type of spark plugs used and the spark plug gap
The TCCM is located on the left side of your Dash, behind the knee panel under the steering wheel, is a small box with 3 plugs and it is attached (clip on) to the BCM (Body Control Module).
is there spark through the wires to the plugs?
no... no spark???? module, crank sensor??? but no such saftey system. only on fuel, enertia switch
It is located above the gas pedal ((about 8") under the dash ,3 connectors from engine side plugs into the module ,the module white sticker part number can be read at the back end of module the number usually starts with 5w...............,that is the module.