0
The knock sensor is just behind the intake manifold on the top of the engine. It is a few inches below the manifold and all you will see is a bolt with what looks like a very thick washer on it with wires coming out of it. The knock sensor appearance has been described as a small donut. Easiest to see while leaning over the left front fender using a flashlight.
What else can I help you with?
Where is the knock sensor on a Subaru Forester 1999?
Where is the knock sensor located on a 1999 Subaru Forester?
Where is the knock sensor on a 2001 Subaru Forester?
The knock sensor is located near the idle air control solenoid valve on a 2001 Subaru Forester. The knock sensor is responsible for sensing vibrations caused by engine knock.
What does the 2000 Subaru Forester knock sensor do?
If somebody knocks on the front door of the Subaru, the KNOCK sensor, sets off the KNOCK Alarm....LOL
What is p0325 engine code for a 1998 Subaru Forester?
Knock sensor/vibration sensor
Is there an online video for replacing Subaru Forester knock sensor?
Yes.
Will check engine light come on with a bad knock sensor on a 1998 Subaru Forester?
Not necessarily.
Why does a 1999 Subaru Forester hesitate under load?
Could be a bad knock sensor. The ECM may be retarding the timing based on bad input from a faulty knock sensor.
Where is the knock sensor located on a 2001 Subaru Forster?
On a 2001 Subaru Forester, the knock sensor is typically located on the engine block, specifically near the intake manifold. It is usually found on the driver's side, just below the intake manifold, mounted on the engine. Accessing it may require removing some components for better visibility and reach.
How do you change a knock sensor on 1998 Subaru Outback?
that the knock sensor does
Where is the Knock Sensor located in a 2000 Subaru Outback Legacy?
It is located on the engine block drivers side.
Where is the knock sensor location on a 1998 subaru legacy?
In a 1998 Subaru Legacy, the knock sensor is located on the top of the engine block and to the left of the engine. More specifically, it is under the left rear intake manifold runner.
What does code P0328 mean for a 2002 Subaru Forester?
P0328 on an OBD11 equipped automobile (everything since 1996) is a knock sensor code. I believe that it says the reading is over the high limit. You should focus on the knock sensor and the wiring leading to it. --Ken
