answersLogoWhite

0

The Power Steering pump for a 2006 Chevy Cobalt is located on the front of the engine, typically near the serpentine belt. It is mounted on the driver's side, adjacent to the engine block. To access it, you may need to remove the belt and possibly other components depending on the specific setup of your engine.

User Avatar

AnswerBot

3mo ago

What else can I help you with?

Related Questions

How much does it cost to fix the power steering on a 2006 cobalt?

I have a 2006 Chevy cobalt and there was a recall to replace the electric steering unit. Check to see if it was done first.


Does a 2006 Chevy Cobalt need a power steering motor to run?

No the power steering is not necessary to run. Steering will be difficult and I wouldn't personally recommend operating the vehicle with out it.


Why does the power steering go out and reset when engine is turned off on a 2006 Cobalt?

i am having the same problem with a 2006 Chevy cobalt ls with 46000miles on it.. if u have a answer email me atLax18chs@AOL.com Subject line "how to fix cobalt power steering". Thanks Ken C


Where to do you put the power steering fluid in a 2006 Chevy Cobalt?

there is no power steering fluid, this is an electric assist power steering system, is you are having problems let the experts handle this go to the dealership.


Where is the power steering reservoir 2006 cobalt?

There is not a reservoir for the power steering it is electronic


Are there any recalls on a 2006 cobalt?

yes for the power steering assist. Talk to dealer.


How do you diagnose a power steering problem in a 2005 Chevy Cobalt?

I have a 2006 Cobalt and about 6 months ago my power steering went out. There isn't really a way to check it besides taking it to a mechanic and having them hook it up to the computer. It's expensive to replace the power steering in these cars. It cost us $600 just for the part because you have to completely replace the steering column. It's really a pain. Hope this helps!


Is it ok to drive my 2006 cobalt with the power steering light on?

There was actually a recall for the power steering. It is covered by the dealership and should be fixed at no cost to you. The recall said the power steering assist will go out and the power steering light will go on.


Remove ignition lock cylinder 2006 chev cobalt?

The ignition lock cylinder on a 2006 Chevy Cobalt is removed by popping off the steering column cover and inserting a screwdriver into the release hole. The cylinder can then be pulled from its housing and replaced.


What would cause a vibration in the steering wheel in a 2006 Chevy cobalt?

Tire out of balance, bent wheel, or if it vibrates only when braking you have a warped rotor.


How do you change the timing belt on a 2006 Chevy Cobalt?

how do you change the timing belt on a 2006 Chevy Cobalt You need to purchase a Haynes Manual at a parts or bookstore.


How do you change a light on a steering column in a 2006 Chevy truck?

How do change a light on a steering column in a 2006 chevy truck?

Trending Questions
Your dash lights dont work on your 95 Nissan pickup any ideas on how to fix this? What does box board look like? What is the thickness of metal brake pipe in a car? Your ford 500 will stop turning over eventhough the battery is fully charged? Power window fuse for a Plymouth Voyager 1993? What would cause the abs light on the dash to stay on all the time on a 1999 ford f150? Will your 1999 Saturn pass smog test if you replace catalytic converter? Where is the transmission oil dip stick located on a 1998 Isuzu Rodeo? How do you remove a billet specialties horn button? What does the button on left side on center console by gear shifter do? Where is the evaporator case on a 1996 Town and Country? What do you do if you put too much oil in your car? Where is the battery ground wire on a 2001 dodge caravan sport? Where can one get Cessna parts? Transmission fluid dip stick on olds alero? Where is the air conditioner filter located on a 2010 dodge caravan how often does it need to be replaced? Safety features of a car? 1997 Chevy Tahoe and i replaced the cam and crank sensors it still won't run will start if i hold the gas down and sounds really bad miss fires and chugs and dies still give codes for cam and crank? Where can you find a cross reference for a Daedong E6201-32443 oil filter? 1991 S10 43 drags when starting replaced the starter battery cable to starter and helped for 1 day started but after dragging down the battery and got worse changed battery but still same problem?