Assuming you are looking for the radiator drain valve, you will find it on the passenger side of the radiator, under the lower radiator hose.
How do you flush the raditor on a 1992 GMC Sonoma Pickup.
How to remove a bad radiator from a 1992 GMC jimmy 4x44-door,v6 engine?....Thank you :)
where do you put freon in on a 2000 gmc jimmy
What type of oil for a 2000 GMC Jimmy
plugged radiator bad water pump bad thermostat
The transmission lines on a 2000 GMC Jimmy 4x4 are replaced by disconnecting the lines at the radiator and then the side of the transmission. They are then removed from the bottom of the vehicle and new lines put in place.
cut upper core support with sawzall flush with radiator sides after removing radiator
Yes, a 2000 GMC Jimmy hood is compatible to a 2000 Chevy Blazer. This is only on the S10 Blazer though.
To flush the radiator of a 1995 GMC Vandura 2500 with a V6 engine, start by ensuring the engine is cool and then remove the radiator cap. Place a drain pan under the radiator and open the drain valve to let the old coolant flow out. Once drained, close the valve and fill the radiator with a mixture of water and radiator flush solution, running the engine for about 10-15 minutes to circulate the flush. Afterward, drain the system again, rinse with clean water, and refill with fresh coolant.
There is an access in the cover below the radiator for the filter.
Look at the bottom or rear of radiator
about 4,200 pounds