The sump plug on a Peugeot Boxer van engine is typically located at the lowest point of the oil sump, which is situated underneath the engine. To access it, you'll usually need to lift the van using a jack and secure it on stands for safety. The plug is usually a hex or square bolt, and it may require a socket or wrench to remove. Always ensure the engine is cool and take precautions to catch any draining oil.
when you look at the van from the front the lowest part of the engine is the sump on the botttom of this is the plug (21mm spanner). when underneath the engine the oil filter is to the front of the sump
The sump plug/oil plug is located at the lowest point of the sump at the bottom of engine.
undo the sump plug at the bottom of the engine
yes. you drain as much engine oil from them sump as you can by undoing the 13mm sump plug. you then undo all the bolts holding the sump onto the engine
All the oil sump plug are on the lower part of the engine, in this case is the same, but you probably will no notice that because it is not a common plug, this car have a square plug.
The sump plug on a Citroën Xsara Picasso is located at the bottom of the engine oil sump, typically on the underside of the vehicle. To access it, you may need to raise the car securely on jack stands. The plug is usually a hex or square bolt, which can be unscrewed to drain the engine oil during an oil change. Always ensure the engine is cool and properly supported before attempting to access the sump plug.
Assuming this is a transverse mounted engine the drain plug is located at the rear of the sump 13mm spanner or socket fits the plug.
To locate the sump plug on a JCB 526S, first ensure the machine is on a level surface and the engine is cool. The sump plug is typically located at the lowest point of the engine oil sump, often on the underside of the engine. It usually has a hexagonal or square head, allowing for easy removal with a suitable wrench. Always consult the operator's manual for specific guidance on your model.
Yes you need a Torx bit to remove the sump plug. Also be careful when you remove the sump plug, there is a O ring on the plug that may fall off. Oh by the way, alot of Astra bolts use Torx (Many manufacturers recomend that you replace the sump plug & o ring)
The sump plug on a Mercedes CLK is typically located at the bottom of the engine oil pan. To access it, you may need to raise the vehicle and use a socket wrench to remove the plug. It's important to ensure that the engine is cool before attempting to remove the sump plug to avoid burns or injury. Always have a container ready to catch the oil when you remove the plug.
The sump plug for a 220e, typically referring to the Mercedes-Benz 220E, is located on the bottom of the engine oil pan. You can access it by getting underneath the vehicle, usually requiring a jack or ramps for safety. It is a hex or bolt-type fitting, which you will need to unscrew to drain the engine oil. Always ensure the engine is cool before attempting to access the sump plug.
Hi the oil drain plug is under the engine on the sump it is very low to the ground so best to drive car up on to ramps to gain access to sump plug. Make sure you do not lose the copper washer on the sump plug hope this helps