The simultaneous illumination of the charge, gas, rear light, and windshield wiper lights in your Mazda 929 likely indicates a malfunction in the electrical system, often related to a failing alternator or battery. When the alternator isn't charging the battery properly, it can trigger warning lights and drain the battery as the vehicle relies on it for power. Additionally, a short circuit or faulty wiring could cause multiple warning lights to illuminate. It's advisable to have the electrical system checked to prevent further battery drain and potential damage.
battery is low. get a boost or charge the battery.
Its likely either the battery connections (terminals) are dirty, or where they connect is...or the battery while showing a charge is bad when on a load. If it starts with a jump from another car...it's the battery.
Change your alternator
It could be the voltage regulator.
needs a coil or distributor it could also be that the alternator isn't working and the car may be draining the battery every time you drive it
It means something is worng with your charging system. Check first your alternator if its charging. Check if belt is loose or broken. Check voltage of battery. Might be undercharged.
The windshield dimensions for a Mazda 3 can vary slightly depending on the model year and specific trim. Generally, the windshield is approximately 58-60 inches wide and 26-28 inches tall. For precise measurements, it's best to consult the owner's manual or contact a Mazda dealership for the specific model year you are interested in.
have you checked the fluid level in the battery.also all batterys lose charge over time if left sitting,specially if battery is getting near 3 years old
i put a new windshield wiper moter in and the fuses are fine but my wipers still wont work
take out the battery, and the battery tray. there it is
There can be 101 problems with your car. Does your battery have a charge? Please be more descriptive if you can.
Changing a battery on a Mazda Tribute is very easy to do. The battery is held in place by a bracket. Take the bracket off and then remove the battery terminals from the old battery. Take the old battery out and replace it with a new one.