0
What else can I help you with?
When I try to turn my bike on it wont turn over. All that you hear is the starter spinning. Is it the Starter Clutch that needs to be replaced?
It can be the starter bendix is not engaging the starter gear into the flywheel. It can also be a broken tooth on the flywheel itself. Try pushing the bike and then releasing the clutch. This will turn the engine over just enough to move the flywheel. If it then engages and starts, suspect you have a broken tooth. If that is not the case, then remove the starter and test it by applying 12 volts and see it the bendix kicks the gear out.
What is a dance word that starts with the letter k?
kicks!
Where is the starter located on a 1994 Chev Beretta 6 cylinder motor?
The starter on a vehicle is always located directly in between the engine and the transmission. When a starter engages, it kicks out a rotating gear that meets with the flywheel of the vehicle, which is also a major component that mates the engine and transmission together. Different vehicle manufacturers mount this component on either the driver or passenger side, depending on the model.
What is wrong if the starter kicks out after turning over the motor about two revolutions?
SAME PROBLEM. Reco Holden 186 engine with a clutch. Engine recently fitted with Yella Terra head and 350 Holley. Compression probably high but starter spins the engine ok. I have a starter moter that drops out, as though the engine has fired. Ive disabled the engine from starting and still the starter drops out after perhaps one revolution of the engine. Ive had the starter out and is working fine. The teeth on the cog show no signs of wear nor are the teeth burred in any way. Anyone would call it a good starter. Took it to a auto elec for a second opionion. Its fine. We agreed it was a good idea to shave off three milimeters from the end of the starter to alow the cog to enter into the ring gear ferther. This done and refitted it still drops out before the engine has a chance to fire. Cover plate removed from clutch and inspected ring gear. A few fine burrs or rather a sharp edge on the ring gear was found. Dident think it would affect the starter but filed off the sharp edge and carefully inspected (and checked with a file) each tooth TWICE! Starter still throws out before the engine fires. Still drops out after about one revolution of the engine.
What should a 1987 corvette engine run for temperature before fan kicks in At what temperature is the motor in danger of overheating?
225 degrees
Why is your BMW 323I 2000 shakes when it starts cold for 20 seconds then the choke kicks in and the engine settles?
It is the VANOS working in conjunction with the cold start injector... once your engine reaches that proper temp, the "shaking" goes away.
Your 1995 GM jimmy died after driving for a minute Now it won't crank over starter kicks in but engine doesn't turn you replaced battery and starter Any clues what to do next?
My first guess would be the fuel pump is bad. Check the computer for codes and see what it says.
You have 1989 Chevy with a 305 engine and 2004r in overdrive it kicks and it let off and kicks in on and off?
EGR EGR
When does ESPN Fantasy Football 2011 start?
Several weeks before the season starts. You are able to create accounts and leagues at any time. The offical league kicks off starts on the second Thursday of September.
How fast can a 1993 Chevy Corsica go before the governor kicks in?
A 1993 Chevy Corsica can only reach 111 MPH before the factory governor will be applied....this is with the 2.2 Liter engine
Who sings and the love kicks starts again?
Kickstarts - Example
Could it be ign switch 71 ford starter stayed engaged not a constant problem had to turn key further too New starter and solenoid in but now starter kicks in when battery reconnected and key not in?
replace the ignition switch
