The 50 ampere engine fuses is blowing because more than 50 amperes of electricity is passing through it.
If you do you will succeed in blowing up the engine.
You need to be more specific about the appliance - dryer or range or air condition- 30 Amp for the dryer, 50 Amp for the range, A/C varies.
The 1999 Ford F2 50 engine block fuses can be found in the fuse box. The fuse box is in the engine compartment, just behind the battery box.
Engine cooling fan RELAYS are located in the under-hood power distribution box. relays #15 and #16. The FUSES that control these fans are also located in the same box: fuse # 2 (30 Amp) and fuse #6 (50 Amp).
Answer for UK, Europe and countries running a 50 Hz supply service.In the UK the power plugs are the standard 240 v 3-pin 13 amp variety and they can be fitted with 13 amp fuses. Other common fuse ratings that can be put in are 5 amps and 3 amps for low-power equipment, and it is also possible to buy other fuses like 1 amp, 7 amps and 10 amps.
Yes.Additional InformationBreakers and fuses protect the wires to prevent fire. The 100 Amp breaker in the meter base (main) protects the wire from the meter base to the breaker panel. The 50 Amp breaker in the breaker panel protects the wire from the breaker panel to the outlet. Sometimes the 100 amp main breaker is located in the panel.If you are asking "Can you use two 50 amp breakers for the main breakers with a 100 amp service, then yes you can. The National Electrical Code allows you to use up to 6 breakers as the main overcurrent protection.
It is in the Main Fuse box. That's the one behind the battery (but not the one on the battery) on the right side of the car on top of the shock tower. There are two 50-Amp fuses in it. It is the one at the bottom of the U-shaped box.
Yes as long as you change the 50 amp breaker to a 15 amp breaker. You will be hard pressed to get the 50 amp #6 wire under the terminals of the 15 amp receptacle.
A 50 amp breaker is an overcurent device.
Drivers side, engine compartment, 50 Amp fuse.
Use a small screwdriver to pry upwards . these fuses are very hard to remove sometimes.
For a 50 amp hot tub installation, a double-pole 50 amp breaker is required.