answersLogoWhite

0

The pre 1997/9 models of Ford Fiesta were self-adjusting via the clutch-foot-pedal. The pedal engages a ratchet system called the QUADRANT & PAWL and is part of the pedal. The mechanism is very similar on older Ford models of: Escort, Fiesta, Sierra, Granada & Transit. Newer vehicles may have a Hydraulic Clutch from 1997/9 onwards, and these work differently from the cable & pully mechanism. Clutch-fluid can be bled to improve the ability to operate the clutch, however this is not necessarily a method of adjusting the clutch.

If your reading this article because you have a broken clutch-pedal then please read on.

If when pressing the foot-pedal it feels like cable is broken, or pedal is loose, ...This is symptomatic of failure of the QUADRANT & PAWL 'ratchet' mechanism due to wear of teeth on the ratchet.

In some cases the pedal fails to pull the clutch out far enough to change gear, and may make a 'springing noise'. This is due to slippage on some worn ratchet-teeth, but the mechanism has not reached full failure.

There are 2 ways to remedy the fault.

1. Change the Quadrant & Pawl, using only genuine Ford parts. #Beware of inferior mouldings that are not up to standard e.g. too soft, and do not trust 'pattern-parts' on eBay etc.

2. SHORTEN THE CABLE.

  • Disconnect SPRING ON THE FOOT-PEDAL to release ratchet mechanism.
  • Clamp cable slack (engine end).
User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

2005 Sunfire clutch is stuck to the floor?

Well, we need lots more information here. Is the clutch pedal actually "stuck" to the floor? In other words, can you NOT lift the pedal up to the normal position? OR, has the clutch pedal "fallen" to the floor due to no resistance from the clutch?


Why does your clutch pedal touch the floor?

It's called: Your clutch is working.


Why does my clutch pedal go straight to the floor and stays down with no pressure?

You have a broken clutch.


Rover mg zt clutch pedal gone to the floor?

The clutch cable has proabably broken.


How can a adjust the clutch pedal on my 1993 Chevy s10 pickup to make it disengage the clutch closer to the floor?

where and how to adjust clutch pedal 1993 s10 It is hydraulic operated, there is no adjustment.


How do you adjust the clutch on a 2008 Chrysler pt cruiser?

depress the clutch pedal to the floor several times


How to Adjust clutch pedal height peugeot 307?

To adjust the clutch pedal height in the Peugeot 307 locate the adjuster bolt on the floor under the clutch pedal. Loosen the bolt and pull out the pedal to the proper height then tighten the bolt. To make the clutch pedal lower for the operator simply push in on the clutch pedal while the adjuster bolt is loose, then tighten the bolt.


Would the clutch pedal going to the floor and staying on the floor be just the clutch going out or what could it be if so and how do you replace the clutch on a 2001 Maxima?

You should not attempt to replace the clutch yourself unless you have considerable mechanical skills. In this case, the problem is most likely that the spring holding the clutch pedal in place is broken.


Can't change gear in ford vista and clutch pedal down to floor?

You may need a new clutch.


Brake fluid is running down the clutch pedal and when you mash the pedal the pedal remains on the floor?

Actually if the fluid is coming down the clutch pedal it is probably your clutch master cylinder going bad or the seal around it. No worries it is a cheap fix. If it is coming down the clutch pedal it has nothing to do with your brakes. Some people well most use brake fluid for the clutch.


What can cause a truck clutch pedal to keep falling to the floor?

If the pedal just randomly falls to the floor, you probably have a broken pedal or linkage. If we are talking about it having no resistance when you press it and the clutch not disengaging, you probably have a leak in your clutch hydraulics. This can be a bad master or slave cylinder, or a leaky line. Bleed the clutch, and then keep checking the fluid daily to see if you are losing it.


Why does the clutch pedal stick to the floor?

You've blown a clutch hose by the sound of it, or you've got a leak in the clutch master or slave cylinder. Either way, without clutch fluid, the clutch pedal wont come off the floor and the clutch will be disengaged. Any half decent mechanic should be able to figure out what the issue is without charging and arm and a leg.