You're likely looking at the oil pressure sending unit.
No, the TR wire on a Robertshaw 7956-336P gas valve does not connect to the positive connection. The TR wire typically connects to the thermostat to control the valve's operation. The positive connection is for the main power supply to the valve.
a loose connection will do that if local near connector
Windstream has always been 2 wire connection. They might be making a 4 wire connection but they do not have it out yet.
it should be on the inlet manifold there will be a wire that slides over the sensor
If you look at the motor it's on the right side it has 2 hoses and one wire connection on it.
Most likely you have a grounding problem in the left tail-light. See if the wire is disconnected, broken or if the grond wire connection is corroded where it connects to the body.
To convert a 4-wire 220V connection to a 3-wire 220V connection, you will need to remove the neutral wire and connect the ground wire to the neutral terminal. This diagram shows the proper wiring configuration for this conversion.
The ignition wire for the 2001 Ford Ranger is yellow. This is the 12 volt constant wire. Other wires in the harness are red and blue.
STAR connection is best suit for 3 phase 4 wire seviceas there is a neautral wire is there in this connection
It is in the computer. You have to buy a computer software and a wire and the port on your truck is below the steering wheel. so you can mess with it while you are driving
in the v6 it's in the wiring harness above the right valve cover. In the others its in the wire at the starter battery connection and there is one other model that has it at the battery end of the wire that goes to the starter.
I have a dodge durango with a hemi and my egr valve is right below the alternator. It looks like a big bottle of pills with the wire connection on the top. Hope this helps