answersLogoWhite

0

Clean the battery terminals, posts, and check the battery for electrolyte compound. Duzzy_06@Yahoo.com did you make sure to connect your hot wire back to the distributor cap If you had no spark before,,,,check the map sensor.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Your 93 caprice alles up and down and go dead especially when it rains?

igniton module igniton module


What can be the problem of a 1994 Chevy Suburban 1500 will not start even though spark plugs coil and distributor replaced and there is no spark?

Is it a brand new distributor ? If not then replace the module and pick-up coil in the distributor that you have.


Electronic ac module on 2003 grand marquis?

where is the ignition control module located on mercury marquis


Would a body control module shut down a car while in driving motion?

Maybe the igniton control module or the ignition module are making bad contact.


94 b3500 v8 runs good then quits wait 20 min then it starts again does same thing changed coil and still the same when it quits dont get a spark from coil need help?

try changing the igniton module (dist. module) usually located on the base of the distributor. hope this helps!


How do you test the coil inside the distributor of a Chevy Camaro that has no spark?

chances are if there is no spark then the ignition module inside the distributor needs to be replaced as far as checking it goes just pop the module out and autozone or advance auto may be able to tell u where to take it to have it tested


Where is your electronic distributor ignition module for Mazda 323 1987?

The module is located behind the Rotor Arm assembly in the distributor itself. You have to remove the Distributor Cap, then the Rotor Arm and the module is there.


How to replace crankshaft position sensor on a 1983 mercury grand marquis 302 v8 engine?

1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.


2000 Chrysler Sebring has power to distributor but no spark to plugs?

It could be either the crank angle sensor or the distributor module. If it is the distributor module, you have to buy and install a re-man distributor.


Number 2 cylinder will not fire 94 ranger?

a bad coil pack or maybe the igniton control module.


Where is a ignition control module a 1987 Chevy blazer s10?

The ignition module is located in the distributor, under the distributor cap.


Where is the ignition control module located on a 96 Chrysler Sebring Coupe LXI?

depends on eng size. The distributor contains the coils and module 3.0 and 2.5 if bad the whole dist needs replaced not servicable