0
Mercury Tracer parking lights may stay on due to a malfunctioning light switch or a faulty relay that fails to disconnect the circuit. Additionally, a wiring issue, such as a short circuit or damaged wiring harness, can cause the lights to remain illuminated. It's also possible that a sensor or control module is malfunctioning. Checking the light switch and inspecting the wiring for damage are good initial steps to diagnose the problem.
What else can I help you with?
What would cause your tail lights and dash light fuse to keep blowing on a 1991 mercury tracer?
you could have a short between the two.
What would be the cause of non-functioning tail lights and reverse lights on the trunk and not the body of a 96 Mercury Tracer?
ck bulbs first then ground circuit and power on trunk lights.Ground most likely
Why would the battery light be on on a 1998 Mercury Tracer?
Needs new alternator.
Why would your dash lights stay on and your parking lights and brake lights 79 Corvette?
== ==
Why would 1998 Mercury Tracer have a rattling noise when turned on?
There is a baby under the hood.
Where is the transmission stick in 1997 mercury Tracer?
On a 1997 Mercury Tracer : The AUTOMATIC transmission fluid dipstick would be on the side of the transmission ( transaxle ) in the area of the brake fluid reservoir . The manual transmission ( transaxle ) does not have a dipstick
What would happen if my 1999 mercury tracer wagon had an abs module failure?
The End Result
Why would the parking lights stay on after the car is put into park and the engine is turned off?
if you leave the parking lights switch "ON" the lights will remain on, even if the car has been turned off.
What would cause smoking wires in the steering column in a 1993 mercury tracer?
Overload or short to ground
What would cause rear parking lights fog lights and instrument lights to not work?
Blown fuse? Damaged buss board?
Does the 1997 Mercury tracer have a fuel pump reset button?
Yes , on the 1997 Mercury Tracer , the fuel pump shut off switch / inertia switch is in the trunk , on the passenger side , up near the rear seat , under the trim ( there would be an access hole or door )
Why does your 1997 Mercury Tracer has no compression what could be the problems?
I just replaced the timig belt on my 97 mercury tracer 2.0, the timing marks are lined up, but i still have no compression at all. Your input would be greatly appreciated. Im asking the question, apparently I'm in the wrong area.
