answersLogoWhite

0

depending on the condition of the old units there could be carbon trace damage. the vent hole could be plugged not allowing the normal condensation to escape. being a victum of a no start in hot weather i found the "main-relay" was defective and very heat sensitive. it is upper left of the stering column and labeled "main relay" the solder joints fail

User Avatar

Wiki User

20y ago

What else can I help you with?

Related Questions

What causes a distributor to send no sparks and if there other part that send sparks to a 1991 Honda accord?

Bad distributor Bad coil Bad distributor cap Bad rotor


1994 Honda Accord ex remove rear rotor?

1994 Honda accord ex remove rear rotor


Good spark and fuel pressure and still no start in a 1992 Honda Accord?

try replacing your distributor, distributor cap, rotor, and maybe the spark plug wires.


Why would a 1992 Honda accord lose its spark?

bad cap or rotor . ignition coil , or ignition mudgule or new or rebilt distributor


Why does my 1990 Honda accord not start when I have changed the plugs distributor cap rotor smell gas when turning over but will not start?

You may have messed up the timing when you put on the new distributor cap.


Why does my number tree cylinder on my 89 honda accord have a weaker spark then the others?

Bad spark plug wire or distributor cap. Replace them both plus the rotor.


2002 Honda accord cranks but want start sometimes?

Tune it up. Replace the spark plugs, plug wires, distributor cap, rotor, fuel filter, and air filter.


How do you change the distributor rotor button on your 98 Honda civic?

To change the distributor rotor on a1998 Honda Civic unplug the spark plug wires from the cap. Loosen the screws and remove the cap on the unit. Be sure to properly line the new cap on the distributor and install.


Why would a 1992 Honda Accord misfire when driving?

A fouled spark plug, high tension wire breaking down, a bad distributor cap/rotor, coolant leaking into the combustion chamber, etc.


Does the hand brake on a 2002 Honda accord work off the rear rotor?

Yes


How can you tell if the rotors on my 2001 4cy accord are pressed on?

If the rotor of the 2001 Honda Accord will does not have mounting hardware it is pressed on. To remove these types of rotors the caliper will have to be unmounted. The rotor will then come off.


How do you change ignition coil on 1995 Honda accord v6?

unplug battery, pull on the distributor cap, remove distributor rotor, slide out dust cover, pull 4 Phillips screws that hold coil in place, remove wiring, replace reversed of removal.