answersLogoWhite

0

The red cap should be plastic or rubber and should be able to be removed. The red cap is a plastic screw top, unscrew it anti clockwise and it will come off. Sometimes pliers are needed as it can be tight.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

How do you replace a battery in a Renault modus?

To replace the battery in a Renault Modus, first, ensure the vehicle is turned off and remove the key from the ignition. Open the hood and locate the battery; disconnect the negative terminal (usually marked with a minus sign) first, followed by the positive terminal. Remove any securing brackets or covers, then lift out the old battery and place in the new one, connecting the positive terminal first and then the negative. Finally, secure the battery and close the hood.


When removing the battery leads from the terminals you do what first?

Disconnect the negative - terminal first, then the positive + terminal. Unfasten the battery hold down clamp. When reinstalling the terminal connections connect the positive terminal first.


How do you remove the battery on a 1999 Ford Escort ZX2?

Disconnect the negative terminal first. Then disconnect the positive terminal. Pull the ends straight up. Unbolt the top of the battery frame and lift up the cover on the battery.


How to install a new battery in your car?

make sure radio settings/presets are saved disconnect negative battery terminal disconnect positive battery terminal unscrew the battery mount take battery out put new battery in put the mount back reconnect battery terminals


How do you replace the positive battery cable on a 1996 Ford Aspire?

To replace the positive battery cable on a 1996 Ford Aspire, first disconnect the negative battery terminal to ensure safety. Then, remove the bolt securing the positive cable to the battery terminal and detach the cable. Install the new positive cable by connecting it to the battery terminal and tightening the bolt securely. Finally, reconnect the negative terminal to complete the process.


Should you disconnect the positive or negative battery terminal first - 45k?

Always the negative cable first.


How do you reset the service engine light on your 1992 wrangler?

Disconnect the POSITIVE battery cable and touch it to the negative terminal OR disconnect the POSITIVE battery cable for about 30 minutes (either way drains the capacitors in the electrical system)


How do you change the positive battery cable on 2001 Toyota Sequoia?

To change the positive battery cable on a 2001 Toyota Sequoia, first, ensure the vehicle is turned off and the keys are removed. Disconnect the negative battery terminal to prevent any short circuits. Then, remove the bolt securing the positive battery cable to the battery terminal using a wrench, and lift the cable off. Finally, attach the new positive battery cable by securing it to the battery terminal with the bolt, and reconnect the negative terminal.


Where is battery disconnect switch on a 2006 Saab 9-3?

It is on the positive battery cable at the terminal. It is the little black box with the yellow button.


How do you remove battery on Renault espace diesel?

To remove the battery from a Renault Espace diesel, first ensure the vehicle is turned off and parked on a level surface. Open the hood and locate the battery; disconnect the negative terminal (usually marked with a minus sign) first to prevent any short circuits, followed by the positive terminal. Once both terminals are removed, unscrew any securing brackets or clamps holding the battery in place, then carefully lift the battery out of the compartment. Remember to handle the battery with care and dispose of it properly.


How do you get your check engine to go out?

disconnect your battery's positive terminal, Wait a couple of minutes then reconnect. All done.


How do you jump start a Renault megane?

To jump start a Renault Megane, first ensure both vehicles are turned off. Connect the positive (red) jumper cable to the positive terminal of the dead battery and then to the positive terminal of the working battery. Next, connect the negative (black) jumper cable to the negative terminal of the working battery and attach the other end to a metal ground on the dead vehicle (not directly to the battery). Start the working vehicle, let it run for a few minutes, and then attempt to start the Megane.