It means ERROR
Its old English for error but also they use it this way because on the screen there usually isn't enough room for the whole word
Hope it helps
radio says safe but cant put the code in
whats number do i put in to unlock radio is it security code or radio code to unlock radio?
1999 Mitsubishi Radio unlock when stuck in "oFF" mode. I found this somewhere else. So many had the answer but with not all of the variables. Sometimes the CODE is written on top of the radio, or you can go to the dealer with proof of ownership and they will get the radio code from your VIN #. Your radio probably says "oFF" right now because you probably tried three different codes that were wrong. Remember you must hit the "TAPE" button to engage the code. After 3 wrong tries, the radio will go into off mode. You will need to leave your key in the first position with everything off except for the radio, in 2 hours or less the radio will change to "code". you can now put in the code that the dealer gave you. If it says "ERR" after you try the code that they gave you----do not try again !!!! Remove the radio and bring it to the dealer or you can write down the letters and #s from the top of the radio and the dealer will have to get you the radio code from those #s. Migaleenne..p.s. Have fun taking it out!
In order to clear the radio code "ERR-3" in a Honda Accord, you simply open the hood and remove the radio fuse (there are two of them so remove the one closest to the car window) for about 10-15 seconds, put it back in and close the box, crank up the car and enter the vehicles radio code(this is usually located on a white card when you first purchase the vehicle or possibly in your glove compartment in the manual), make sure you enter the code correctly, and then the error will be removed and you can start playing music in your car! If you do not have the code then go to the Honda Owners website and register your Accord. After you register it you can get the code for free.
The Mitsubishi Eclipse radio code is the code that makes your radio work. You need to put this code in any time you disconnect the battery.
my 2001 diamante radio wont turn on after i put the code in
Zero
Try getting it from radiocodeking.co.uk/renault-radio-codes/ as they give codes for free. After you put your serial code, put this coupon code: freerenaultcode to make it free.
Through radiocodeking.co.uk/jeep-radio-codes and their great offer, you can get the radio code for free. All you have to do is put the radio serial and the voucher code: freejeepcode upon the checkout page (making it free).
melvsta here, ye take it out, u'll need a special radio removal pins, fit either side of radio, check fuse on back of radio, if that's ok, its most probably wiring fault, if radio does turn on and it says 'error', its a Renault job to fix hopefully under warranty, if it says code, check your handbook for code and instructions how to put in, good luck
the radio has message error 6
you go on line and you put your code in the little box that says code here