0
What else can I help you with?
Remove lighter socket from 2013 dodge durango console?
how to remove lighter socket from 2013 dodge durango console
What socket for 1998 dodge Dakota starter bolt remover?
The starter bolts on a 1998 Dodge Dakota require a 5/8 inch socket or wrench.
Where are the TRANSMISSION input and output speed sensors on a 2002 Dodge Intrepid?
They are on the driver's side of the transmission, and require a 1 inch deepwell socket to remove, and you may need some extensions to reach it.
What size socket do you need to remove the thermostat from a dodge grand caravan 2000?
That depends on the engine. I believe that the 2.4L needs a 10mm socket, the 3.0L uses a 12mm, and the 3.3L/3.8L use a 13mm socket to remove the housing bolts.
How do you remove a cigarette lighter socket in 2006 dodge stratus?
To remove the cigarette lighter socket in a 2006 Dodge Stratus, first, disconnect the negative battery cable to ensure safety. Then, use a flathead screwdriver to carefully pry off the trim surrounding the lighter. After removing the trim, you can access the socket and disconnect the wiring harness attached to it. Finally, unscrew the socket from its mounting and pull it out.
What size socket is needed to remove the rear hub bearing nut on a 2000 dodge stratus?
30mm
How do you remove spark plugs fromm 99 2 7 dodge intrepid there is a ledge in the cylinder even with the bolt of the spark plug no socket i have found will grab the plug is there a special tool?
A normal 5/8 spark plug socket should work just fine.
How do you remove timing gear on 94 dodge 2.5?
There is a special tool ( a puller ) to remove the crankshaft sprocket.There is a special tool ( a puller ) to remove the crankshaft sprocket.
What kind of wrench is needed to remove the front caliper bolts on a 2005 dodge stratus?
7mm hex socket
What is the axle bolt size of a fwd dodge stealth non turbo sohc?
It is a 33mm socket you will me to remove the nut
How do you remove spare tire on Dodge ram without tool?
If you don't have the tool a 13mm socket should work
How do you replace the crankshaft sensor on a 1994 Dodge Ram?
The crank sensor is located behind the passenger side head, in through the bell housing. It is held in place by two bolts that require a 5/16 Allen socket to remove.
