0
What else can I help you with?
Should the head bolts on a 1990 Toyota Camry with a 2.5 ltr engine be replaced when doingheadgasket?
Yes you never reuse headbolts
How do you change the EGR valve on a 1994 Toyota Camry?
The egr valve is located on the top rear of the engine. It bolts on and is easily removed.
How can you remove and replace the radiator on a 2002 sequoia?
The radiator on a 2002 Toyota Sequoia can be removed and replaced by first draining the coolant. The cooling hoses can then be disconnected, the retaining bolts removed, and the radiator pulled from the vehicle.
How do you remove Toyota Previa dashboard 2001?
The dashboard on a Toyota Previa is held on with several bolts. All must be removed. After the bolts are removed so must be the remaining clips. The dashboard that has to be carefully removed from the cabin of the vehicle.
Can the flywheel be removed and replaced without removing engine or transmission i'n 1978 Chevy 350 motor?
NO. You will have to remove all the transmission bolts and slide the transmission back enough to get a wrench and your hand between the engine and transmission to remove the fly-wheel bolts.
How do you remove the passenger side mirror from a 1996 Toyota Avalon Three bolts have been removed but it still does not come off?
I just replaced my side mirror. After the bolts are removed you need to work it side to side. It has a tight seal. You also have to remove door panel to unplug the wire that works the mirror.
How much is the torque of 2c cylinder head bolts Toyota?
torque for 2c engine cylinder head bolts
What are the torque specifictions for Toyota 20R crank bolts?
The Toyota 20R engine crankshaft bolt torque specification is 150 pounds. The crankshaft bolts should be torqued in 50 pound intervals.
How do you remove the top two bell housing bolts on a 1991 Toyota pickup?
you first remove the engine mounting brackets, then you place a jack under the transmission and remove the cross member bolts that hold the transmission up. after the bolts are removed you can lower the transmission down which will tilt the motor back allowing access to the top 2 bolts from the back side
Where is the thermostat located on 1995 Toyota 4 runner?
Location is dependent on the type of engine. Some ideas to assist are; It will be located where one of the hoses from the radiator enters the engine. There will be a mushroom shape to this connection point. Nuts or bolts will hold this connection point. When you remove the bolts and connector you will see the old thermostat, ( or a place it should be if someone removed it).
How do you remove driver side engine-transmission mount on a 95 grand am?
Support the engine gently by spanning a wood 2x4 across the middle of the pan and jacking it up slightly. Then remove the engine mount at the upper passenger side. The entire bracket must be removed from the engine. This is necessary so that the engine can be slid to the right when removing the transmission mount along with its engine bracket. The bracket must be removed to or else the transmission mount can't be removed. There will be a total of 8 bolts to remove to allow the transmission mount to be removed. There will be a total of three nuts and 6 bolts to remove to allow the engine mount to be removed. Two of those bolts are accessed from inside the wheel well.
How do you change an oil pan 1991 ford crown Victoria?
In order to replace the oil pan on the Crown Victoria you have to remove the engine from the car. After the motor has been removed then you remove the bolts holding on the oil pan and it can be replaced.
