answersLogoWhite

0

What else can I help you with?

Related Questions

In a nonelectronic small engine ignition system which of the ignition components is energized by the power source first?

In a nonelectronic small engine ignition system, which of the following ignition components is energized by the power source first?


If there is no power to an hei coil on an 86 305 how would you go about getting power to it?

Check the ignition fuse also check the ignition switch


Does fuel shut power off to the ignition?

No, fuel does not shut power off to the ignition. Instead, the ignition system is responsible for generating the spark needed to ignite the fuel-air mixture in the engine. Fuel delivery and ignition are separate systems; if the fuel supply is cut off, the engine will stop running, but the ignition system can still be powered on.


If your getting power to the coil can the Crankshaft sensor prevent you from getting fire?

crankshaft sensoryes because if the ecm isn't getting a signal from the sensor it doesn't know at what orientation the crankshaft is and won't let the ignition system start the engine. that's how i understand it to work


What is distributor power source on 95 Prizm with 1.6 eng?

The distributor power source on a 1995 Chevrolet Prizm with a 1.6L engine is typically the ignition switch, which provides power to the distributor when the ignition is turned on. The distributor is responsible for directing the high voltage from the ignition coil to the correct cylinder in the engine. It also contains the ignition timing mechanism, which plays a crucial role in engine performance. If you're troubleshooting, ensure that the wiring and connections to the distributor are intact and that the ignition coil is functioning properly.


How do you tell if ignition switch is bad?

To determine if an ignition switch is bad, observe symptoms like the dashboard lights flickering, the engine failing to start, or the key getting stuck in the ignition. You can also test the switch by checking for power at the ignition wire when the key is turned to the "on" position. If there's no power or inconsistent readings, the ignition switch may be faulty. Additionally, listen for clicking sounds when turning the key, which can indicate internal problems within the switch.


What can be the problem on a 82 firebird 5.0 if there is no power getting to the injectors?

the computer and the ignition module give power to the injectors.


What is spark ignition engine?

A 'spark ignition ' engine is your regular gasoline engine as opposed to a diesel, which is a 'compression ignition' engine


How does power get to a 300zx coil?

Power gets to a 300ZX coil through the ignition system, which includes the ignition switch, ignition relay, and wiring harness. When the ignition key is turned, power flows from the battery through the ignition switch to the ignition relay, which then sends voltage to the coil. The engine control unit (ECU) also plays a role by controlling the timing of the spark, allowing the coil to generate a high-voltage spark needed to ignite the fuel-air mixture in the engine's cylinders.


Not getting electrical to ignition system of 1961 Ford Falcon?

I've replaced ignition switch, and starter solenoid, checked fuses, and battery, but I don't seem to be getting any electrical through to start the engine. I can jump everything and get the engine to turn over but not start.


Isuzu Rodeo 2000 won't start?

Check the ignition coil for power. Check the crank position sensor, and make sure that the engine is turning over ( timing belt not broken.) Check to make sure that fuel is getting to the engine as well.


Which engine has highest compression ratio?

the diesel engine. it takes one ignition to start, then it runs off of (autoignition) ignition from heat caused by high compression. compression ignition (autoignition) causes ignition to happen a little earlier than spark ignition engines (gas engines) which is less vulnerable to risk of engine knocking or wasted power when dealing with high compression. -maddmatt