answersLogoWhite

0

What I did was let the engine cool down then open the radiator cap and turn on the engine. Let the engine idle for about 10-15 min to make sure it had circulated the coolant. Between those 15 min you should see bubbles and that's bleeding the radiator you're removing the air, and this is how I did it because after a radiator flush I left the engine off when I poured the new antifreeze and it was over heating but now that a let the air out it's much better.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How do you bleed air from radiator of a 2000 range rover?

How do you bleed air from radiator of a 2000 range rover?


How do I bleed a radiator to remove trapped air and improve its efficiency?

To bleed a radiator, locate the bleed valve at the top of the radiator and use a radiator key or screwdriver to open it slightly. As air escapes, you will hear a hissing sound. Once water starts to come out, close the valve. This will remove trapped air and improve the radiator's efficiency.


Where is air bleed valve on radiator for subaru legacy?

no air bleed valve. all you need to do is to remove the radiator cap and let the car idle for a few minutes.


What is the bleed valve on the radiator?

its a valve to let the air out of the system


Do you have to bleed air from radiator if you change top hose only?

Yes.


How do you bleed air from 1992 clio?

squeeze bottom hose, undo bleed valve on right hand side of radiator to let air out


What are some instructions on how to bleed a radiator?

Bleeding a radiator means to let out any air that could be trapped inside the radiator. The first step is to turn on the heating of your home to get the radiators hot so one could tell which radiators contain air. Next would be to bleed the radiator for air and then check the pressure.


What is the screw on the thermostat hub that is attached to the radiator hose on a 1997 transport?

I would guess to bleed out the air in the system when you fill it after loosing fluid or after changing or flushing the system.


How do you bleed the air out of the coolant system on a 1997 Pontiac Montana?

If it has bleeder valves then use them to bleed the system, if not, jack up the front of the vehicle as high as possible. Remove the radiator cap and start the engine. Add coolant to keep the system full. This will allow air to escape.


How do you bleed the air out of a 94 grand am?

To bleed the air out of a 94 Grand Am, remove radiator cap and place a pan under the pipe. Turn the nut counterclockwise about one quarter turn with the use of a hex wrench. This will bleed the air out.


How do you bleed the fuel system in a 2002 eclipse gs 2.4L automatic?

If This Is To Remove Air From Fuel Lines. Forget It. You Do Not Have To Bleed The Fuel Line.


How do you bleed a radiator to remove trapped air and improve its efficiency?

To bleed a radiator, you need to locate the bleed valve usually found at the top of the radiator. Use a radiator key or a flathead screwdriver to slowly open the valve until you hear a hissing sound. This will release any trapped air in the radiator. Once water starts to come out, close the valve. This process helps improve the radiator's efficiency by allowing hot water to flow freely through the system.