To change the front transmission input shaft seal on a 1985 Subaru Brat, first, support the vehicle and remove the transmission from the vehicle by disconnecting the necessary components, including the driveshaft and any electrical connections. Once the transmission is out, use a seal puller or a flat tool to carefully remove the old seal from the input shaft. Clean the area thoroughly before installing the new seal, ensuring it's seated evenly. Finally, reassemble the transmission and reinstall it in the vehicle.
It is on the front of the transmission, next to the cooler hoses.It is on the front of the transmission, next to the cooler hoses.
Input Speed Sensor is on Front of Trans closer to the engine. Output is on the front, farther to the drive side. Both are two wire sensors.
It is in between the cooler hoses on the front of the transmission.It is in between the cooler hoses on the front of the transmission.
The input and output speed sensors are on the front of the transmission case. Both are two wire sensors. The input is closer to the engine.
They are the two wire sensors on the front of the transmission case. The input is closer to the engine.
The input and output speed sensors are the two wire sensors on the front of the transmission case. The input is closer to the engine.
The input speed sensor is the two wire sensor on the front of the transmission case closest to the engine.
The slave cylinder is on the input shaft of the transmission at the throw out bearing. The transmission will have to be removed to change it.
It is on the front of the transmission, between the cooler hoses.
They are the two wire sensors screwed into the front of the transmission case. The input is closer to the engine.
On the driver side of the transmission case there are two sensors that have two wires going to them. The input sensor is the one closer to the front.
it should be on front of transmission.