0
What else can I help you with?
How do you replace harmonic balancer in 1999 Lincoln town car?
Harmonic balancer replace
How do you change a harmonic balancer on a 1999 Montana?
To change the harmonic balancer on a 1999 Pontiac Montana, first, disconnect the battery and remove any obstructions, such as the serpentine belt and crankshaft pulley. Use a harmonic balancer puller to carefully detach the old balancer from the crankshaft. Once removed, clean the crankshaft and install the new harmonic balancer, ensuring it is properly aligned. Finally, reassemble any removed components and reconnect the battery.
How do you change a harmonic balancer on a 1999 Jeep Cherokee 4.0 L?
Remove the belt. Remove the bolt that attaches the harmonic balancer. Rent or purchase a harmonic balancer puller. Follow the Instructions with the puller and remove the old balancer. Install the new balancer making sure to line up the keyway, a little oil helps. Put the retaining bolt back in and tighten to manufacture specs.
How do you install a harmonic balancer on a 1999 Chevy Silverado with a 5.3?
The engine has a harmonic balancer on it, but if it is off, it is easy to re-install. Simply line up the key and tap it on most of the way and torque down the center bolt.
Why does my 1999 dodge Dakota shout down after drivn for a few minutes?
If your Dakota shuts down after 5 or 10 seconds then change the map sensor. If it shuts down after 3 or 4 minutes of driving and won't restart look for a bad harmonic balancer. Experienced both!
Where is the crank sensor located on a 1999 Dodge Stratus 2.4 4-cylinder and is it diffucult to change?
BEHIND THE HERMONIC BALANCER ON BOTTOM OF ENGINE
What tool are needed to change a harmonic balancer on a 1999 dodge ram 2500?
A three jaw puller, a serpentine belt tool, and sockets/wrenches.A three jaw puller, a serpentine belt tool, and sockets/wrenches.
Does the intake manifold on a 1999 Buick Century have to be removed in order to replace the cam shaft position sensor?
no it;s behind the harmonic balancer take off passenger right front tire and you can get at it. you will need a wheel puller to pull the harmonic balancer off
What causes drivetrain vibration from 45 to 55 in a 1999 kia sportage 4x4 u-loints appear fine?
Harmonic balancer
Where is the crank shaft position sensor on a 1999 gmc safari van?
The CPS is located on the front of the engine attached to the harmonic balancer on the front of the crankshaft.
How to remove the harmonic balancer on a 1999 5.7 vortec?
You need a socket to fit the holding nut and a large gear puller. Instructions are in the manual for the vehicle.
Where is the crank sensor on a 1999 gmc suburban 1500 5.7 4x4?
It is bolted to the bottom left side of the timing cover / behind the harmonic balancer.
