answersLogoWhite

0

Need more information as there are a few different types. Year, make, model, and engine size is the information that will be needed.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

1990 70HP evinrude will not fire?

3 things are required. air, fuel, and ignition. check plug. if wet, change plug. if dry, check for fuel issue. if there is no spark, check ignition system. easy. =)


How do you check the ignition circuit?

To check the ignition circuit, start by inspecting the ignition switch and its connections for any signs of damage or corrosion. Use a multimeter to test for continuity in the ignition coil and wiring, ensuring there are no breaks. Additionally, check the battery voltage to ensure it’s sufficient, and verify that all fuses related to the ignition system are intact. Finally, if equipped, examine the ignition control module or distributor for proper functioning.


Why no ignition light?

The reason for no ignition light could be a low battery. The wiring system may be another reason for this. Check the white wires in the ignition switch and the multi-plug connector to ensure they are connected.


1987 Z24 NISSAN pick up cuts out at 2500 rpm?

check ur fuel system.. pump, filter and injectors.. if doesnt fix it, check ur ignition system..


A primary advantage of the electronic ignition system over conventional ignition systems is?

a primary advantage of the electronic ignition system over conventional ignition system is?


How do you troubleshoot a 1998 Jimmy ignition?

To troubleshoot the ignition system of a 1998 GMC Jimmy, first check the battery to ensure it has a full charge and clean connections. Next, inspect the ignition coil and spark plugs for wear or damage, replacing them if necessary. Use a multimeter to test the ignition switch and wiring for any faults. Finally, check for any trouble codes using an OBD-II scanner to identify specific issues within the ignition system.


Your 1989 Mercury Topaz will start but won't stay running What should you check?

If your 1989 Mercury Topaz starts but won't stay running, you should check the fuel system, including the fuel pump, fuel filter, and fuel injectors. Additionally, check the ignition system for issues with the spark plugs, ignition coil, or ignition module. Finally, inspect the air intake system for any blockages or leaks that could be affecting the engine's ability to run smoothly.


How to test ignition system in 2000 Ford Ranger?

You can check the ignition module (coil) with a digital volt/ohm meter for a start. Check the primary and secondary circuits resistance and go from there. You can also check the spark plug wires resistance with the same meter.


When it was raining hard and damp your engine cut out why?

check your ignition system for openings where moisture is causing your spark to ground


Is it possible for the chip in the ignition key for a Cadillac to go bad?

Yes, its not uncommon. Check first to see if the security light is on, on the dash. This will indicate a passlock problem in the ignition system.


What would cause a 2003 ford focus to shake and loose power all of a sudden?

If the 2003 Focus is running good then suddenly shakes and looses power, check the fuel system for proper pressure. If the pressure is correct, check the ignition system for fire, the ignition components could be starting to fail.


Who invented the ignition system?

Nikolas Tesla invented the ignition system in 1898.