To install a trunk lock on a 1991 Buick Park Avenue, first, remove the trunk lining to access the lock assembly. Disconnect the electrical connector if the lock has a keyless entry feature, then unscrew the old lock from its mounting bracket. Install the new trunk lock by securing it in place with screws, reconnect the electrical connector if applicable, and replace the trunk lining. Finally, test the lock to ensure it operates smoothly.
yes, it does in my 1991 buick park ave.
Check out Crutchfield.com
The Buick Park Avenue Started In 1991
Go to autozone.com then check out the repair guide. You probably will not like doing that job.
Remove the power trunk release, it may be stuck and holding the latch to the open position. I had same problem and found that if I use the key to unlock power lock then closed trunk - it worked.
10w30
3
replace the truck motor, or spray the existing one with wd40 to be sure all moving parts are well oiled.
The Buick Park Avenue nameplate was first used in 1977 on a model of Buick Electra, but did not exist as a standalone model until 1991, when it replaced the Electra.
I own a 1991 buick park avenue ultra. I'm sure it's in the same place as the buick. I just had that done. It is located on top of the steering column. You must take the front panel off in order to reach it. I would suggest that you go to an electrical shop. It is a dunting job.
fuel pessure test
5 QTS