To open the hood on an Oldsmobile in the 50's with a broken hood latch cable simply insert a screwdriver (preferably a phillips because it is usually more slender) into the hole that is just below the point where the cable attaches to the latch it self. To access the hole reach under the grill bar and just behind and above the grill bar on the shroud that goes between the radiator and the grill bar. The hole will let you use the screwdriver to activate the hood latch. It takes a bit of feeling around to find the hole.
yes
To open the hood on a 1966 Oldsmobile Toronado, locate the hood release lever inside the vehicle, typically found on the driver's side near the kick panel. Pull the lever to release the hood latch. Then, go to the front of the car, slide your hand under the center of the hood, and feel for the secondary latch. Release this latch to fully open the hood.
To open the hood of a 2004 Kia Sedona with a disconnected cable, first, locate the hood release lever inside the vehicle, usually found near the driver's side footwell. If the lever is not functioning due to the disconnection, you may need to access the hood latch directly from under the vehicle. Carefully slide underneath and use a flathead screwdriver or similar tool to push the latch mechanism to release the hood. Alternatively, you can remove the grille or front cover to gain access to the latch if necessary.
On a 91 regency it's located in the center under the hood near the hood latch assembly!! Dave
Either hold down slightly on the hood and pull the latch or hold the latch and pull up on the hood. The lock becomes dry and doesn't release. Spray with WD40 or similar product.
Mine went and the wire for it is located right near the hood latch in the front . I taced it back a litttle and sniped it so then I just pull the wire from the front to open it.
To replace a hood latch on a 1995 F-150, the old hood latch will have to be cut out with a blow torch. The new hood latch will have to be welded in place. Securing with bolts after welding will make the hood latch stronger than that of the original.
The hood is openned by a cable that links the handle in the car the hood latch. If the cable is broken or detached then the hood will not open. The cable has two parts, an outer covering and the actual cable that pulls on the hood latch when the inside handle is pulled, you need to check the inside handle to see if the cable is still attached to the handle, also you need to check the hood latch to see if that end is still attached to the hood latch. If either is disconnected the you will need to get appropriate hardware(nuts,bolts etc) to attach it back but if the cable is broken it has to be replaced complete. This you might or might not be able to do depending on you skill and proficiency with tools.
A hood latch is the mechanism that holds your vehicles hood in the closed position while in operation.
dodge truck broken hood latch
To remove the hood latch on a Jeep Wrangler, first, open the hood and locate the latch mechanism. Using a socket wrench, remove the bolts securing the latch to the hood. Disconnect any cables attached to the latch, if applicable, and then carefully pull the latch away from the hood. Reassemble in reverse order if you're installing a new latch.
You can close the hood latch, on your Chevrolet Malibu, by gently pushing downward on the hood. The latch may need to be sprayed with a lubricant.