answersLogoWhite

0

The top cover is held down by two spring clips, approx 4" in from each side. There is also an alignment pin with a washer on it just outside each spring clip... (Looking from the front, into the crack between the top lid and the front cover, these alignment pins fooled me into thinking that the top lid was screwed down to the front cover.... that was wrong!).

To open the top cover:

Insert a flat pry-bar or large flat-blade screwdriver near the clips and pry up on the top cover... be careful not to chip the paint. The spring clips will "let go"... it takes a fair amount of pressure to get them to release.

Once the lid is loose, you lift it like a car hood... it is "hinged" at the rear.

When the lid is lifted, you will then see the tops of two 5/16" hex-head sheet-metal screws, one at each corner, which hold the front panel onto the rest of the washer. To get access to the motor and the lower portion of the washer, just remove these two sheet metal screws and lift up on the the front panel to remove it.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Why your amana refrigerator water don't work?

You get a new one.


Why doesnt window washer work in 1992 Town Car Wipers work ok but washer doesn't work?

need windshield washer motor


How does the Amana heat pump work?

An Amana heat pump works just like an air conditioner would work. When the temperature outside starts falling, the heat pump automatically turns on and by reversing the process of turning air cold, it heats the air instead, thus allowing you to keep your home warm.


What type of windshield washer does an altima Nissan teakes?

Any brand washer fluid will work.


Will a car pass a mot if the windscreen washer does not work?

no


How do you get washer fluid to work in 1987 wrangler when the wipers work fine?

There is a pump motor in the bottom of the washer bottle that pushes the fluid. Check to see if it might be dead.


What would make a washer on a stackable unit not work if the dryer does?

Does the washer not work at all, or does it just not work when it's trying to rinse? It may be a lid switch. If the washer does not work at all, it may be the timer. Pull the timer from the unit and check to see if any of the "fingers" are stuck, sticking, or burnt. If so, change it. The timer is the "Brains" of the washer... it tells it when to start, cycle, & stop. Sounds to me like this is more than likely your problem. The washer allowed water to be drawn in and then went to "L".


The windshield washer on your 2002 Pontiac sunfire does not work is there a fuse for that and if so where is it located?

I believe if you open the drivers side door and open the fuse panel access door located on the dash you will see that there is usually a fuse in there for the washer pump. If the fuse is OK, the problem might be the pump, usually located in the bottom of the resevoir. They are notorious for dying. Replacements can be found at your local parts store.


'Why wont my clock turn on i hit the dash it would work but not now Why cant the back windw washer spray work And the front driver door doesnt open i now press keyless button then open w key'?

Sounds like you need to buy a new car. One that is idiot-proof.


How do you work a mp3 player that's been in a washer?

You don't.


How does a Kenmore wringer washer work?

Works very well.


What are the reasons my stratus window washer does not work?

cuz your stupid