To remove the ignition switch from a 1966 Bronco, first disconnect the battery to ensure safety. Next, remove the steering column cover by unscrewing it, then locate the ignition switch mounted on the steering column. Disconnect the wiring harness from the switch, and remove any screws or bolts securing the switch in place. Finally, pull the ignition switch out of its housing to complete the removal.
The 1966 Chevy Impala ignition switch can be removed by loosening the retaining ring at the top of the ignition switch. Remove the wiring harness. Reverse the process to install the new ignition switch.
Wiring on early Bronco switches, (1966-77) at least are removable. There is a plug with a nut on the back of the switch. remove the nut, then pull the single wire off of the threaded stud. The rest of the wires are in a plug which will just pull of now that the nut is removed. Hope this helps.
Just remove one screw inside car, under the dashboard near the ignifion switch area.
remove the silver ring that is on the dash buy turning it with channel locks, it should be threaded
Undo the chrome ring at the front of the ignition, the ignition switch assembly can then be removed from the back of the dash. Unplug the lead in the back remove the ignition switch & throw it in the bin. You could try drilling the barrel out, it would probably be best to buy a complete new assembly, you wont get the old barrel out without a key. You will also need new door locks.
== ==
Could be a bad ignition switch....
Ford Bronco was created in 1966.
"First, insert the key into the ignition tumbler. Proceed by turning the key counter-clockwise until the key is in the "accessory" position. Using a paper clip or pick tool, depress lockout pin while turning the key counterclockwise approximately 1/8 of a turn. The tumbler should then release. Remove tumbler from ignition switch. Note the position of the tumbler as it is being removed from the ignition switch, making sure not to turn the key as it is being removed from the switch. Align the new key and tumbler in the same position. Be sure the flat edge at the end of the new tumbler matches the same position as the old tumbler. You will more than likely need to suppress the pin on the face of the tumbler as shown in video in order to match the same flat edge position. " - Copied with permission from tomsbroncoparts.com. They also provide a video of how to do it here: http://www.tomsbroncoparts.com/pages/instructional-videos/how-to-install-a-ignition-switchtumbler-into-a-1966-1977-early-ford-bronco/
The power of the engine of the ford bronco 8cyl 1966 is 200 hp
Bronco Mendenhall was born on 1966-02-21.
The car that Ivy drives on the show 90210 is a 1966 Ford Bronco, the first year they were made. The Bronco is a vehicle that was produced from 1966 until 1996.